what inputs are required to run 722.6?
Thread Starter
Member
Joined: Feb 2017
Posts: 171
Likes: 13
From: Kansas
1999 SLK 5.5L 6-speed, 1993 300 SE
what inputs are required to run 722.6?
Good evening everybody, I'm in the middle of swapping a 4.3 V8 into my '99 SLK, and will be running the car off megasquirt, however I believe it will need to be ran in parallel with the stock harness for the purpose of giving the ECU all the information it needs for the transmission. so my question is: what sensors on the engine are needed to control the transmission? if none, then I can remove the engine harness completely. I anticipate that the Crank Position may still need to be hooked up..??
Thanks in Advance.
here Is the build: http://www.slkworld.com/performance-...l-v8-swap.html
Thanks in Advance.
here Is the build: http://www.slkworld.com/performance-...l-v8-swap.html
Thread Starter
Member
Joined: Feb 2017
Posts: 171
Likes: 13
From: Kansas
1999 SLK 5.5L 6-speed, 1993 300 SE
I will finish this for anyone curious.
the 722.6 on pre-05 cars uses the crankshaft position sensor, camshaft position sensor, throttle position sensor and throttle body. In other words, if using a 722.6 in something else, or with a standalone engine setup, you will need these items plugged in for the transmission to work properly.
the 722.6 on pre-05 cars uses the crankshaft position sensor, camshaft position sensor, throttle position sensor and throttle body. In other words, if using a 722.6 in something else, or with a standalone engine setup, you will need these items plugged in for the transmission to work properly.
Newbie
Joined: Aug 2021
Posts: 2
Likes: 0
From: Cameroon
w203
I need help on this 🙏🏾
I will finish this for anyone curious.
the 722.6 on pre-05 cars uses the crankshaft position sensor, camshaft position sensor, throttle position sensor and throttle body. In other words, if using a 722.6 in something else, or with a standalone engine setup, you will need these items plugged in for the transmission to work properly.
the 722.6 on pre-05 cars uses the crankshaft position sensor, camshaft position sensor, throttle position sensor and throttle body. In other words, if using a 722.6 in something else, or with a standalone engine setup, you will need these items plugged in for the transmission to work properly.
