iCarsoft MB II can't start regen
08-08-2022, 05:40 PM
#1
Junior Member
Thread Starter
iCarsoft MB II can't start regen
Again and again I am getting the P24AF error code. I know it's my NOx sensor.
I tried many times to start the DPF regeneration from my iCarsoft MB II scanner, but it always gives me an "application failed" error.
Has anyone successfully done that?
I tried many times to start the DPF regeneration from my iCarsoft MB II scanner, but it always gives me an "application failed" error.
Has anyone successfully done that?
08-29-2022, 10:37 AM
#2
Member
My iCarSoft MBII will not even go to the regeneration screen.
After asking "Car or Van" , I hit Car and it checks then comes up with the correct vin. Then asks "Is this the correct vin.?" I hit "OK' for Yes. It then just ges back to "Car or Van".
Does this over and over.
After asking "Car or Van" , I hit Car and it checks then comes up with the correct vin. Then asks "Is this the correct vin.?" I hit "OK' for Yes. It then just ges back to "Car or Van".
Does this over and over.
