Hydraulic Trunk Motor problems
Thread Starter
Newbie
Joined: May 2019
Posts: 4
Likes: 0
S 320
Hydraulic Trunk Motor problems
Good day
I need help. I drive a W220 and the hydraulic pipes that go from the pump to the cylinder has gone through. I cut the piece out that has worn through. Now I need to know if there is a way of joining the two open ends again. I have tried everything but pressure is so high that it just keeps pushing the joints out.
Please assist as I would like to try and mend this and avoid buying a new unit
Many Thanks
I need help. I drive a W220 and the hydraulic pipes that go from the pump to the cylinder has gone through. I cut the piece out that has worn through. Now I need to know if there is a way of joining the two open ends again. I have tried everything but pressure is so high that it just keeps pushing the joints out.
Please assist as I would like to try and mend this and avoid buying a new unit
Many Thanks
Newbie
Joined: Mar 2019
Posts: 13
Likes: 1
From: Hawaii
2000 S500
Solution.
There is. You can pick up some compression fittings at almost any hardware store. I use them all the time at work on air, fuel and brake lines all the time. They are very cheap, and easy to work with/install. If you've never done them before, then YouTube will be your best friend.
