Easy entry exit
#1
Junior Member
Thread Starter
Join Date: Oct 2007
Location: Chicago
Posts: 70
Likes: 0
Received 11 Likes
on
7 Posts
2014 S550, 2013 GL450
Easy entry exit
I just discovered something new. I thought there was something wrong with my front seat memory. After getting into the car the seat would position itself into the memory position but would not recline as far as I have it set. After two service visits, we checked it against another S550 and the same thing occurred. Apparently when the easy entry and exit function is enabled, the seat can only recline to a certain point automatically. At that point you need to hold down the memory button to recline to the stored memory. This only occurs when you set the recline in memory pasta certain point.
I guess you discover something new all the time, albeit this one is annoyng.
I guess you discover something new all the time, albeit this one is annoyng.
#3
Out Of Control!!
Join Date: Jul 2003
Location: North Scottsdale, AZ
Posts: 15,903
Received 4,435 Likes
on
3,152 Posts
'71 Pinto
Speak with the shop foreman there “may” be a setting in Star Diagnostic System (SDS) to increase both seat & recline travel. I know there was an easy entry/exit reset & option to increase seat travel back further for the 211 – worth a shot to ask/explore.
#5
MBWorld Fanatic!
Join Date: Dec 2006
Location: Europe
Posts: 6,380
Received 295 Likes
on
247 Posts
223.168 & 213.012 & 906.633 & 214.005
Almost obvious. Did you ask him to find out if there are any?
Just checked Xentry diagnosis and there seem to be related menus but those are password protected and I cannot access them to check the details. The workshop would need to request a password too, don't accept them to stop at what is available straight away.
Just checked Xentry diagnosis and there seem to be related menus but those are password protected and I cannot access them to check the details. The workshop would need to request a password too, don't accept them to stop at what is available straight away.
#6
I just discovered something new. I thought there was something wrong with my front seat memory. After getting into the car the seat would position itself into the memory position but would not recline as far as I have it set. After two service visits, we checked it against another S550 and the same thing occurred. Apparently when the easy entry and exit function is enabled, the seat can only recline to a certain point automatically. At that point you need to hold down the memory button to recline to the stored memory. This only occurs when you set the recline in memory pasta certain point. I guess you discover something new all the time, albeit this one is annoyng.