New MB S55 AMG owner question.




maw
FWIW many to most 'Merikanski type cars steering assist is of the flavor that one could give the wheel a good twist and have it spin to the lock with exactly zero zip nadda feedback through the wheel while driving. That is not how it goes in your German car.
As as for it wanting to follow road crown or wandering on crummy pavement.... Be sure all suspension goodies are in good shape... That tires are fresh and aired up... That alignment is good... And enjoy the car.
Shudder before shift can be symptom of a weak spring in a valve body, or a sticky or loose valve body in its sleeve. You can also find a resleeve repair kit for the trans.
Shudder can also be indicative of a worn out transmission mount’s rubber isolator that fastened into the center cross brace. Not too hard to swap that one.
Another weak component is the circuit board attached to the valve body. If you drop the transmission pan and valve body, you should also swap in a new circuit board. And the electrical connector socket that usually leaks.




Cheers,
maw
Trending Topics
The Best of Mercedes & AMG
I didn’t do a fluid change to clear anything wrong. I did have an old Ford Crown Vic 30 years ago with a stutter vibration that did clear up after a fluid change.
my experience on the S55 was:
56k miles I swapped trans fluid/filter when I figured the time was about right for preventative maintenance on what was supposed to be a “lifetime fluid”. (Later determined by MB USA to be a crock of horse feathers).
77k I replaced trans mount, and the front guibo/flex-disk on drive shaft front end when I felt a vibration developing at 2.2k RPM. That helped clear it up.
84k swapped trans fluid, filter again. Also replaced the connector at that time because it had a persistent small leak.
Re: Transmission recalibration: I don’t think it does much for me. Doesn’t seem to hurt but doesn’t make it feel any different. Relearns your average driving after another bunch of days regardless. So drive like you want to drive. Floor it if you can afford to fix it.
Last edited by GrepAwk; Feb 11, 2020 at 01:53 PM.




@GrepAwk: I change my fluid often too, and have done all mounts. My question, however, was do you think changing the fluid clears up the valve body issues you highlighted?
maw
Last edited by maw1124; Feb 11, 2020 at 01:52 PM.




If you have the VMI and/or CarFax, posting those may help folks here help you.
maw




As far as this thread goes, two lingering questions I have about this car are:
(1) whether trans fluids now come with cleaning additive packages similar to engine oil which helps valves and springs in valve bodies move more freely. My guess is Yes, but I haven’t dug deep enough to confirm this. I use redline type F racing fluid in my 500E with a new valve body and can tell the difference. Maybe I’ll talk to them directly about it’s use in this car; and
(2) whether the TCU learns anything when you’re driving in M mode. My guess is No, for logical reasons. Still need to confirm that.
Otherwise, once you get over the ABC hump, the car is plug and play, easily one of the most reliable and easy to maintain cars I’ve owned (but mine deleted all the parktronic, keyless go, distronic and other gadgets).
maw
Last edited by maw1124; Feb 15, 2020 at 08:25 AM.
If you have the VMI and/or CarFax, posting those may help folks here help you.
maw
Not sure about your questions on the trans learning while in manual mode.




maw
maw
The factory installed filler tube cap had a little red lock tab on it. You need to pinch or twist off that red tab to loosen up the cap for removal.
The dipstick will be pretty long. It probably won’t go all the way in. Don’t worry. It’s not meant to be left in the car like the oil dip stick. It’s only used for temporary measurements. The important thing to notice is when the plastic gauge tip bottoms out in the pan and that’s where the trans fluid level will be read on the end of the stick.
I didn’t replace the red lock tab on the cap. I just push the old cap back on the end of the tube and I check it every few weeks to make sure it didn’t come off.






