SL/R129: ADS adjustment
05-19-2005 | 04:32 PM
#1
Thread Starter
Member
Joined: Mar 2005
Posts: 149
Likes: 0
Received 0 Likes
on
0 Posts
From: Norrtälje, Sweden
SL60 ///AMG
ADS adjustment
I have now switched the failed control-button for the ADS on the side if the steering wheel, and it´s seems that I have run the car in fail-safe mode for 1,5 years 
It was discovered when I replaced the control unit for the rollbar and still had the controllamp for the hydraulic system still on.
However, I have earlier done some work on the control units (under the car, in the front and back) to get the right level on the car (low), but now when the control-button is fixed, the height is back to normal (too high for me) despite the earlier adjustment. The question is -Can I use a control-unit from the dealer pluged in to the big conector in the engine compartment to adjust the height?
It was discovered when I replaced the control unit for the rollbar and still had the controllamp for the hydraulic system still on.However, I have earlier done some work on the control units (under the car, in the front and back) to get the right level on the car (low), but now when the control-button is fixed, the height is back to normal (too high for me) despite the earlier adjustment. The question is -Can I use a control-unit from the dealer pluged in to the big conector in the engine compartment to adjust the height?
Last edited by SL60 ///AMG; 05-19-2005 at 04:50 PM.
