SL/R230: Drivers Window
Thread Starter
Junior Member
Joined: Nov 2013
Posts: 45
Likes: 0
From: Virginia Beach
2011 SL550
Drivers Window
My drivers window when I raise it first comes up about 3 inches and stops. Then 2 try goes all the way up and then I raise the rear window the 2 inches to seal. Is there a reset?
MBworld Guru
Joined: Dec 2009
Posts: 10,782
Likes: 1,011
NO LONGER ACTIVE
Try pulling fuse #9 (left side panel under the hood) for a few minutes. This will reset the door controller. You'll then need to re-sync the windows with the door closed. Pulling up fully on the switch until the glass raises to the top, then hold for five seconds. If this does not work, you may have a bad door controller or a problem with the window regulator.
Thread Starter
Junior Member
Joined: Nov 2013
Posts: 45
Likes: 0
From: Virginia Beach
2011 SL550
Thanks
Try pulling fuse #9 (left side panel under the hood) for a few minutes. This will reset the door controller. You'll then need to re-sync the windows with the door closed. Pulling up fully on the switch until the glass raises to the top, then hold for five seconds. If this does not work, you may have a bad door controller or a problem with the window regulator.
