Scan Gauge II owners
#1
Super Member
Thread Starter
Scan Gauge II owners
Does the Scan Gauge II convert the boost into PSI?
Most are in bar and you have to subtract 14.5 to get the correct reading.
What is the scan rate? Faster than 1 second?
Most are in bar and you have to subtract 14.5 to get the correct reading.
What is the scan rate? Faster than 1 second?
#2
MBWorld Fanatic!
Does not go faster than one second in "FAST" mode - also only available in PSI as far as I can recall - you typically will see 25 or so for a stock car and 28-29 for a ASP pulley car - gives total PSI not the boost over atmos. Remember if you alter your ecu software there is a good chance the scangauge wont work any more....