Anyone replaced their cams themself?
10-10-2011, 08:29 PM
#1
Senior Member
Thread Starter
Anyone replaced their cams themself?
Hi guys got a few questions for anyone who replaced their own cams on a E63?
1- do i need the tool that looks like a plate that does in the front?
2- how do i keep tension on the adjuster?
Got 2 tools, a kind of straight edge and a M shapped tool .
I DO NOT NEED TO KNOW HOW HARD IT IS
I DO NOT NEED TO BE TOLD TO TAKE IT TO A DEALER
Thanks
1- do i need the tool that looks like a plate that does in the front?
2- how do i keep tension on the adjuster?
Got 2 tools, a kind of straight edge and a M shapped tool .
I DO NOT NEED TO KNOW HOW HARD IT IS
I DO NOT NEED TO BE TOLD TO TAKE IT TO A DEALER
Thanks
Last edited by ertech; 10-10-2011 at 09:03 PM.
10-10-2011, 10:25 PM
#2
MBWorld Fanatic!
Didn't you post this in the C63 section too?
I know you don't want to take it to the dealer, but just a word of advice.
After you put the cams back in you need to time them.
If timing is not done properly, your gonna start bending valves when your pistons hit top dead center.
I know you don't want to take it to the dealer, but just a word of advice.
After you put the cams back in you need to time them.
If timing is not done properly, your gonna start bending valves when your pistons hit top dead center.
Last edited by _AMG_; 10-10-2011 at 10:32 PM.
10-10-2011, 10:29 PM
#3
Senior Member
Thread Starter
yes I did but only replies I got was not to do it ,just need the awnsers to my questions.
thanks for any replies in advance.
thanks for any replies in advance.
10-10-2011, 11:01 PM
#5
Senior Member
Thread Starter
Yes that is why I am asking here to get a tech to awnser me or someone
Who has done it
Who has done it
Last edited by ertech; 10-11-2011 at 12:28 AM.
