On some menus I will get the " Do you want to over right this yes or no" before you get to your actual program.Does this mean that I will be able to change something only if I select yes? Some things will not have that message at all. Also for the life of me I still can not find the SBC count. I know its in Bremseuzahler-Brake payer under control gear and most of it is in German. If not I will have to get another lap top running next to me to convert German to English...pita!.....Thanks

 

Ref your first question. That usually occurs because the computer program is checking to see if you want to erase the previous encounter. If you were working on your first MB, and now you want to work on your wife's MB, you need to overwrite the first encounter. If you only own one MB, say "No" and it will keep the data from the previous time you connected your car to the diagnostic system.


https://mbworld.org/forums/w211-amg/...ml#post6392219

 

SBC Reset Procedure in attachment

* At your own risk *

 

Thanks so much for the information !!!!!!

 

OK here is where I am at now.I still can not get into the SBC as far as the counter check. I can read pump cycles only and pressures. I also seem to have "lost" information. There where things I could find like EGR and Air pump information under variant coding but now it's no where to be found.Its almost like the programs do not exist anymore but I have been in them before.

When going into SBC... Developer data and control gear should be under chassis correct?

Also I always only have one green light on the bottom right corner ...is this correct?