When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have one available again. If anyone wants it PM me. I can also recode the TCU for the gear ratio.
Do you have part numbers for the HAG 215 axle bearing Snap ring shims and/or the multi pack of them? I'm going to install a wavetrac and will need the assortment or to order the thicknesses I need.
Thanks, I need MB p/n's for these shims, there are several but they may have an assortment pack. If I can get one part number I can call and ask about the other thicknesses. If someone here has them gathering dust and would like a return on them,,,,,,,,,,,,,.?
The Wavertrac 48.309.185 WK is an aftermarket limited slip that replaces the the internals of the list of vehicles below.
The side bearing pre-load is set by using a case spreader and dial indicator set @0 and spread no more then .012". Bearings and snap rings are installed and the spreader released showing a desired retained spread of .007-.009" and remove the spreader.
This is adjusted via different thickness snap rings.
Then you move onto the back lash also adjusted with the snap rings but you have to keep the same total amount of shim thickness to maintain side bearing preload but shuffling the shims on both sides or you loose side preload. A common cause of failure because its overlooked. Some don't use a spreader and wing it and complain the Wavetrac is unreliable or noisy. Or get lucky.
03-01-2021, 02:14 AM
