What Gear and AWD config to use on dyno?
#1
MBWorld Fanatic!
Thread Starter
What Gear and AWD config to use on dyno?
As the title states
What gear have the majority of you used to dyno (biturbo 63) 4th or 5th?
what was the configuration for the AWD reading on the dyno setup?
Thx
What gear have the majority of you used to dyno (biturbo 63) 4th or 5th?
what was the configuration for the AWD reading on the dyno setup?
Thx
#3
MBWorld Fanatic!
Is it supposed to be 5th but everyone uses 4th or is 4th showing the right numbers?
#4
#5
MBWorld Fanatic!
#6
Any gear with a higher then 1.1 ratio will always read slighty off. It's hard to explain but for the most part hp will be relative and very accurate using the next closest gear. But peak tq is best measured in 1.1 ratio. With that said because hp is a calculation of tq over time. The best measurement is at 1.1. And with all that said all dyno numbers are really useless. The only thing that ever matters while using a dyno is gains shown. Dyno numbers really mean nothing and should only be measured to show gains or loss.