Vegetax

Anyone know what this code is: P06AF00- Torque Management System- Forced Engine Shutdown?

thanks

Plutoe

You can help yourself by googling the fault code, as there are over a thousand hits---wada you get!

Vegetax

no ****! I already did, there is not much for the e63. Take your smartass post somewhere else.

Ralcbah

What are your mods? If tuned, by whom? I'll check my logs to see if I've seen this one.

Vegetax

tuned by eurocharged, full turboback, intake spacers.

Ralcbah

Don't have record of that one. Did it throw you into limp mode, with cel, until restart? We're you driving particularly hard at the time?

Silverp30wagon

How long have you had the car?
How long have you had the tune?
What year and mileage?
What were you doing when it happened?


Thanks,
Andy
​​​​​​​

Vegetax

The car did not go into limp mode, I had the 02 sensors cel and this one appeared too. It caught my attention since the car runs fine, however I dyno the car last week and my torque numbers where low for the mods I have. I was thinking maybe this cel is preventing my car to put down higher torque numbers. I did tuned the car when it was stock, however I have not yet updated my tuned since adding the mods.

Vegetax

Like i said, i dont think you will get this check engine light unless you have another one. I dont know how long its been there, i saw your post regarding eurocharged. Maybe its on the tuning, I'm thinking of changing tuners to be honest. Did you blow your turbos? How did it happened?

Silverp30wagon

I didnt run the EC tune for even 200 miles. After local tune it runs fine, even with almost 700 torque at rear wheels. Where are you located?

chiromikey

What year car? Check with your dyno operator to find out if he dyno’d properly using dyno mode. If he didn’t that may be the cel that comes up and it will erase itself after 50 starts or something like that.

Vegetax

2012, this cel was on before dyno.