AMG E63 S Milage
#1
AMG E63 S Milage
Hi Guys,
I’m from the Netherlands and I want to buy a Mercedes Benz E63S AMG, with a mileage with 130.000km.
Is it safe to buy a AMG with this milage, they say all the services is done by MB.
Thank you
I’m from the Netherlands and I want to buy a Mercedes Benz E63S AMG, with a mileage with 130.000km.
Is it safe to buy a AMG with this milage, they say all the services is done by MB.
Thank you
Last edited by RajivK; 05-16-2022 at 02:20 AM. Reason: Pictures
The following users liked this post:
cotmfk (05-16-2022)
#2
MBWorld Fanatic!
Joined: Jul 2013
Posts: 2,436
Likes: 706
From: Toronto, Ont, Canda
go fast grocery getter wagon
Just be prepared to have some pricey repairs as it aged.
mine is 4.5 yrs old with 86,000km and I had air suspension and ignition coils replaced. Very pricey. Overall, the engine and tranny seem to be without any issues thus far.
mine is 4.5 yrs old with 86,000km and I had air suspension and ignition coils replaced. Very pricey. Overall, the engine and tranny seem to be without any issues thus far.
#3
Thank you for the fast reply.
I did a test drive yesterday, and it drove well.
No error messages seen, the air suspension worked great.
The intercooler has been replaced,
What do you think of the gearbox, how is the shift.
The services:
2021-03-25 Den Haag(Place)124.000KM
2021-02-24 Moordrecht(Place)104.000KM
2018-10-08Roeselare(Place)88.000KM
2018-05-18Roeselare(Place)53.000KM
2017-12-19Roeselare(Place)33.000KM
2017-10-13Roeselare(Place)16.000KM
I did a test drive yesterday, and it drove well.
No error messages seen, the air suspension worked great.
The intercooler has been replaced,
What do you think of the gearbox, how is the shift.
The services:
2021-03-25 Den Haag(Place)124.000KM
2021-02-24 Moordrecht(Place)104.000KM
2018-10-08Roeselare(Place)88.000KM
2018-05-18Roeselare(Place)53.000KM
2017-12-19Roeselare(Place)33.000KM
2017-10-13Roeselare(Place)16.000KM
Last edited by RajivK; 05-15-2022 at 02:50 PM.
#4
MBWorld Fanatic!
Joined: Jul 2013
Posts: 2,436
Likes: 706
From: Toronto, Ont, Canda
go fast grocery getter wagon
The tranny shifts fine in general, it may shift a bit more jerky per se in race and sports +.
at 130,000km, the tranny fluid should have been replaced by now. Also, at this mileage, the spark plugs and battery should be as well.
the one big unknown could be the electronic gremlins.
at 130,000km, the tranny fluid should have been replaced by now. Also, at this mileage, the spark plugs and battery should be as well.
the one big unknown could be the electronic gremlins.
#5
Super Member
Joined: May 2009
Posts: 737
Likes: 160
From: Laguna Niguel
'94 SL600,'05 SL600,'06 S65,'07 E63,'14 E63S,'09SL600 all sold, ‘15 S65,‘18 E63S,'17 SL65, '17S65Cab
There were a lot of recall campaigns on the 2017 and 2018. If that is the year you are considering, look for documentation they have all been completed. The most important one is the retrofit of protective screens over the intercoolers. One that a lot of people like is the retuning of the suspension response.
#6
MBWorld Fanatic!
Joined: Jul 2013
Posts: 2,436
Likes: 706
From: Toronto, Ont, Canda
go fast grocery getter wagon
Op said the previous owner serviced at dealer, so all service bulletins would have been done.
one added note, the e63 front suspension has an aggressive camber setup, my front tires had a bad inner tire which worn much faster the other sections of the tire. So, do check your tires for irregular wear often.
one added note, the e63 front suspension has an aggressive camber setup, my front tires had a bad inner tire which worn much faster the other sections of the tire. So, do check your tires for irregular wear often.
Last edited by bobblehead; 05-15-2022 at 05:00 PM.
#7
Trending Topics
#8
The tranny shifts fine in general, it may shift a bit more jerky per se in race and sports +.
at 130,000km, the tranny fluid should have been replaced by now. Also, at this mileage, the spark plugs and battery should be as well.
the one big unknown could be the electronic gremlins.
at 130,000km, the tranny fluid should have been replaced by now. Also, at this mileage, the spark plugs and battery should be as well.
the one big unknown could be the electronic gremlins.
That the shift is more jerky?
I added some pictures,
Last edited by RajivK; 05-16-2022 at 02:22 AM.
#10
MBWorld Fanatic!
Joined: Jul 2013
Posts: 2,436
Likes: 706
From: Toronto, Ont, Canda
go fast grocery getter wagon
#12
MBWorld Fanatic!
Joined: Jul 2013
Posts: 2,436
Likes: 706
From: Toronto, Ont, Canda
go fast grocery getter wagon
I believe it is pretty straight forward.
If you are going to do the change, then do:
brake fluid
rear diff
tranny fluid
oil
How are the brakes ? A lot of life left ? The OEM rotors are crazy expensive and I cannot find much choice for aftermarket brands for them.
Again, you should have your mechanic check out the front tires wear for any excessive wear on the inner tires.
If you are going to do the change, then do:
brake fluid
rear diff
tranny fluid
oil
How are the brakes ? A lot of life left ? The OEM rotors are crazy expensive and I cannot find much choice for aftermarket brands for them.
Again, you should have your mechanic check out the front tires wear for any excessive wear on the inner tires.
#13
MBWorld Fanatic!
Joined: Jul 2013
Posts: 2,436
Likes: 706
From: Toronto, Ont, Canda
go fast grocery getter wagon
both of my front tires had this low speed blowout on local roads. Lucky me as I was about to go onto the highway too. The tires were at around 30,000km mark when this happened. After the tires were replaced, my MB dealer checked over my front wheel alignment and they were pretty well within factory spec. So, the dealer has no words on what happened to the tires in the end.
#15
MBWorld Fanatic!
Joined: Jul 2013
Posts: 2,436
Likes: 706
From: Toronto, Ont, Canda
go fast grocery getter wagon
I know. But I am just showing the wear on the inner tire was excessive when compared the the outer side. Both tires were like that. This one was blown and the other one removed immediately and was probably a few hundreds km from being blown as well. Just to add one more note, the front tire pressure was put between 38-40 psi at the time.
#16
I like to look at older AMGs for sale - you can see them being sold with much higher mileage than that. AMGs can last a very long time. Just depends on maintenance and accident history.
The following users liked this post:
RajivK (05-16-2022)
#17
MBWorld Fanatic!
Joined: Feb 2007
Posts: 2,373
Likes: 636
From: Cary, NC
2024 AMG EQE SUV , 2021 E63S Wagon - gone, 2018 E63S Sedan - gone
I know. But I am just showing the wear on the inner tire was excessive when compared the the outer side. Both tires were like that. This one was blown and the other one removed immediately and was probably a few hundreds km from being blown as well. Just to add one more note, the front tire pressure was put between 38-40 psi at the time.
Last edited by HBerman; 05-16-2022 at 12:22 PM.
#18
MBWorld Fanatic!
Joined: Jul 2013
Posts: 2,436
Likes: 706
From: Toronto, Ont, Canda
go fast grocery getter wagon
Don’t really know. The tires were on their 3rd year of usage and with about 30,000km on the clock. I now have the Michelin a/s 4 and in the 2nd year of usage.
I don’t track my car at all and only do some spirited driving once in a while.
bottom line is I just hope the e63 owners will take a few minutes of the time to check theirs especially if they are 3 yrs old or older
I don’t track my car at all and only do some spirited driving once in a while.
bottom line is I just hope the e63 owners will take a few minutes of the time to check theirs especially if they are 3 yrs old or older
#19
Congrats on the new car @RajivK
I replaced my Michelin PS4S at 9,000 miles (14,000km). I am glad that wasn't a more serious event...good on you to share it as a heads up for other members: check the full width of the tread for wear.
I replaced my Michelin PS4S at 9,000 miles (14,000km). I am glad that wasn't a more serious event...good on you to share it as a heads up for other members: check the full width of the tread for wear.
#20
I know. But I am just showing the wear on the inner tire was excessive when compared the the outer side. Both tires were like that. This one was blown and the other one removed immediately and was probably a few hundreds km from being blown as well. Just to add one more note, the front tire pressure was put between 38-40 psi at the time.
I know its a "comfort" thing, but the s/w213 is a heavy car, and should have tires inflated as specified, which results in a somewhat stiff ride.
#21
MBWorld Fanatic!
Joined: Jul 2013
Posts: 2,436
Likes: 706
From: Toronto, Ont, Canda
go fast grocery getter wagon
The issue is air pressure....at 10psi below the recommended cold fill levels, you were concentrating the weight on the inner portion of the contact patch, which generates wear and heat which ultimately led to your sidewall failure along the belt junction
I know its a "comfort" thing, but the s/w213 is a heavy car, and should have tires inflated as specified, which results in a somewhat stiff ride.
I know its a "comfort" thing, but the s/w213 is a heavy car, and should have tires inflated as specified, which results in a somewhat stiff ride.
I am saying my cold front was set at around 38-40 psi at the time, not when it was running and hot. There are lots of owners here are running around 40-42 cold psi, thus, I was not far off.
One quick google on "MB inner tire wear" will produce many hits, ranging from S class to our E class.
Last edited by bobblehead; 05-16-2022 at 02:56 PM.
#25
Yes hard to believe but OEM there is no longer Front Camber and Caster or Rear Camber !
Essential to adjust tire contact angles spread load more evenly. Besides costly, premature, tire wear excess edge load can also lead to higher impact, ruptured side walls, rim damage. Adjustment allows to cater for day to day commuting encountering high cambered roads, fitting low profile tires, wheel squat through load carrying or lowering or just having adjustment capability for curb knock damage.
The often quoted re-assuring “Full Front & Rear 4 Wheel Alignment” in fact IS ONLY TOE (DIRECTIONAL ADJUSTMENT).
It’s all to do with cost cutting and the ever increasing speed of auto assembly lines.
We saw the need to re-instate once again from the early 90’s full Front and Rear adjustment.
W213 E53, 63 AMG
FRONT CAMBER #503416-1i $345 (Both Sides)
Less then cost of 1 Hi-Performance Tire - Fit without arm removal.
CAMBER & CASTER #503416K $480 (Both Sides)
Caster bushings are Monoball / 2 Axis significantly improving brake & steering response.
REAR CAMBER (& Extra Toe) #502326-1K $480
Unique patented design - all kits are precise single wrench adjustable accurately (under load) - direct on alignment rack.
KMAC - Experience Of Resolving OEM Suspension Shortcomings Since 1964 !
Essential to adjust tire contact angles spread load more evenly. Besides costly, premature, tire wear excess edge load can also lead to higher impact, ruptured side walls, rim damage. Adjustment allows to cater for day to day commuting encountering high cambered roads, fitting low profile tires, wheel squat through load carrying or lowering or just having adjustment capability for curb knock damage.
The often quoted re-assuring “Full Front & Rear 4 Wheel Alignment” in fact IS ONLY TOE (DIRECTIONAL ADJUSTMENT).
It’s all to do with cost cutting and the ever increasing speed of auto assembly lines.
We saw the need to re-instate once again from the early 90’s full Front and Rear adjustment.
W213 E53, 63 AMG
FRONT CAMBER #503416-1i $345 (Both Sides)
Less then cost of 1 Hi-Performance Tire - Fit without arm removal.
CAMBER & CASTER #503416K $480 (Both Sides)
Caster bushings are Monoball / 2 Axis significantly improving brake & steering response.
REAR CAMBER (& Extra Toe) #502326-1K $480
Unique patented design - all kits are precise single wrench adjustable accurately (under load) - direct on alignment rack.
KMAC - Experience Of Resolving OEM Suspension Shortcomings Since 1964 !