When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
AMG DRVU - AMG DRIVE UNIT DTC (1) 1.P0AB602 - Actuation for engine mount ''B'' has an electrical fault or an open circuit.There is a general signal fault.
I changed both mounts but still give same error as current and stored. Seems the issue somewhere else , but where and what to check?
Nevertheless, the thing to do is measure if there’s a signal arriving at the engine mount. That should have probably been done before going ahead with replacing the mounts. Most likely a faulty connection somewhere or the wires themselves.
Sub-Code = P0AB6-02 / P0AB602
General Meaning = Short to Ground
Possible Causes = Wiring harness shorted to ground, damaged component, faulty insulation.
Diagnostic Steps = Inspect wiring for shorts to ground, check component grounds, repair damaged insulation. Also check the acceleration sensors.
Sub-Code = P0AB6-02 / P0AB602
General Meaning = Short to Ground
Possible Causes = Wiring harness shorted to ground, damaged component, faulty insulation.
Diagnostic Steps = Inspect wiring for shorts to ground, check component grounds, repair damaged insulation. Also check the acceleration sensors.
Do you know where I can find wiring diagram etc..?
I have the same code on both sides. When I did my research I came to on a software update as the first step to cure this problem. I have attached the search. The problem is it's expensive to get the update.I was actually looking at getting a scanner to do the update myself. A lot of the scanners promise the world , but they don't do what they promise.
Launch X431 Pro5 vs pro3 v elite 2026 modules
I was looking at 1 of these 2 models, but when I emailed them, they havent responded yet. All the reviews that received these unitsd said it was great. Then they never said anything again about it.
If someone could chime in thst this might work , it could be a big , helpful resource for us all.
I have the same code on both sides. When I did my research I came to on a software update as the first step to cure this problem. I have attached the search. The problem is it's expensive to get the update.I was actually looking at getting a scanner to do the update myself. A lot of the scanners promise the world , but they don't do what they promise.
Launch X431 Pro5 vs pro3 v elite 2026 modules
I was looking at 1 of these 2 models, but when I emailed them, they havent responded yet. All the reviews that received these unitsd said it was great. Then they never said anything again about it.
If someone could chime in thst this might work , it could be a big , helpful resource for us all.
Thats interesting , I have x431 Elite 2025 but i dont know how to update it..
I don't think that one can do it.It's only a diagnostic scanner from what I can see. For what I can tell you have to have one of the two I have stated above or a more expensive one from them.
I don't think that one can do it.It's only a diagnostic scanner from what I can see. For what I can tell you have to have one of the two I have stated above or a more expensive one from them.
Finally solved, changed both mount's and error gone. But interesting that adaption showed that both mounts were good..
And what I mean here is that previously i changed already both and now under warranty 2 weeks later they changed both again and issue solved, seems x-files mystery.
Mercedes SLR McLaren 722 S Is Extremely Rare Example Modified by McLaren
Slideshow: A one-of-one U.S.-spec Mercedes-Benz SLR McLaren Roadster became even rarer after a factory-backed transformation at McLaren's headquarters.
