Bulletins 207 coupe & 212 sedan
Is there a history of this complaint made by you on previous visits before 12K elapsed?
Have you talked to the Service Manager? MBUSA?
LI91.10-P-054143 JUL13 – 204, 207, 212 and 218 seat fore/aft adjustment nonfunctional, replace motor, shafts and motor retaining plate.
LI05.1o-P-056435 JUL13 – 276, 278 and 157 engines rattling noise after start for several seconds, install check valves/replace left & right secondary chain tensioners.
LI68.10-P-056727 JUL13 – 207, 212 and 218 glove box squeaks/rattles, attach felt to mounting at top left.
LI46.35-P-055485 JUL13 – 204, 212, 207 and 231 with direct steering (code 211) engine does not start, or various fault messages in IC immediately after engine start and servo assistance reduced, update steering software.
LI91.10-P-056733 AUG13 – 207 rattling noises from backrest while driving, install felt.
LI30.30-P-056782 AUG13 – 218,166, 172, 204.9, 216, 231 production date 4/1/13 to 6/30/13 with Distronic plus (233), system occasionally reacts too sensitively to vehicles in adjacent lane, perform initial startup of radar sensors control unit - may contain default values instead of vehicle-specific values.
LI54.65-P-056779 AUG 13 – 212 & 207 facelift (804), 117 Parktronic cannot display any obstacles only ready LED lights up, update control unit software.
LI82.70-P-056963 AUG13 – 207, 212, 218 Connect device function in Telephone menu is sometimes grayed out following system start although Bluetooth is activated it is then not possible to set up a connection between phone & COMAND, update COMAND online control unit software. Note: Problem is rectified after bus idle or after resetting COMAND (hold down ON button for 8 seconds).
LI82.60-P-056890 AUG13 – 212 no/poor AM radio reception, insufficient ground connection of antenna amplifier.
LI88.20-P-056908 AUG13 – 212 (954, P96 or 772) facelift wind noise/whistling at windshield, possible cause gap between bumper & chrome surround of radiator trim – see picture.
LI07.08-P-057165 AUG13 – 212, 204, 164, 221, 230 with 272 & 273 engine radiator fan runs at 100% + fault code 2237 stored, update ME control unit software.
LI54.71-P-056477 AUG13 – 212 & 218 with Blind Spot Assist (234) or Active Blind Spot Assist (237), 164 with (234) inoperative, replace radar sensors with additional silicone sealing.
LI30.30-P-057139 AUG13 – 212 & 207 with Collision Prevention Assist (258) may warn for no obvious reason, update CPA control unit software.
LI82.85-P-057169 AUG13 – 212, 207, 218, 221 with retrofitted iPhone Drive Kit Plus COMAND display flickers or briefly turns green/red/black, replace audio-video adapter cable from Apple - not claimable under warranty.
LI54.30-P-056977 AUG13 – MY2014 212, 207, 218 analog clock sporadically executes a normalization sequence, replace clock with part # 2188270070. Sunlight rays can pass through the face to the inside causing the IR sensor to detect loss of synchronization the clock then runs a normalization sequence.
LI82.85-P-057016 AUG13 – 212, 207, 218 with retrofitted iPhone Drive Kit Plus stability improvements (poor sound quality, distorted audio output, etc.), update DKP control unit software. Following parts are affected: 1728700296, 1728700496, 2128200376, 2128200476, 1768200176.
Last edited by konigstiger; Sep 8, 2013 at 01:27 AM.
HOWEVER
, LI30.30-P-057139 AUG13 – 212 & 207 with Collision Prevention Assist (258) may warn for no obvious reason, In my MY 2011 212 P2, we frequently get a "beep beep" for no reason, no cars or any kind or obstruction nearby, no chance of police or other radar emissions. And there is absolutely no message of any kind. Disconcerting at times . . .
Is it possible that's what this notice is talking about?




Could you please translate what NAG2, OM651 / OM642 are? I have a 2013 E550 with this issue. I had the vehicle into the dealer last week, but the technician said that the latest software is installed.
LI27.19-P-056898 AUG13 – All models with NAG2 in combination with OM651 or OM642; 218 & 212 with 278 + 4matic delayed start-off from standstill / lurch when coming out of power-free state / jolt when brakes are released, update software.




The Best of Mercedes & AMG




The car IS starting in D1 when in "S" mode. The engagement surge that I was feeling (depressing the left paddle) is due to the transmission clutches being reengaged after running free. Also, MBUSA says that the jolt that I have been noticing is NORMAL (WAD) for engine 278 and 4Matic. The bulletin applies to MY2012 and up if the transmission software update had not been installed. The additional tip about greasing the drive shaft to address the issue apparently does not really fix the complaint, but can lessen the jolt if there was inadequate grease.
Anybody got the bulletin I can take to my dealer?
LI82.85-P-057192 SEPT 13 – 212, 218 w/COMAND NTG 4.5 Gen2 intermittently no audio output regardless of selected source immediately after engine start, update COMAND control unit software.
LI82.85-P-057191 SEPT13 – 212, 218 w/COMAND NTG 4.5 mute function that was activated before last ignition off is intermittently no longer active, update COMAND control unit software.
LI88.50-P-057020 SEPT13 – 218 with AMG rear spoiler lip, trunk lid does not open fully via remote unlocking increase preload of spring by moving to the fourth hole on both sides.
Front noise left side on low speed , dealer was no help
Local shop did inspection , verdict - front struts / or front upper mounts get loose

Asked dealer again to do inspection , success - dealer is going to replace both front struts under warranty
After this checked Bulletins , i think this is a common issue with these cars
LI32.25-P-051123 FEB11 – 212 without Airmatic (489), 207 without vehicle dynamics (483)
dull thumping noises or metallic rattling from the area of the front axle occurring @ speeds 10-45 mph, modified front struts should be installed.
many thanks to konigstiger
will report if issue get fixed
Last edited by champaign777; Oct 23, 2013 at 12:57 AM.
improves harsh 3-4 and 4-3 and 4-5 harsh shifting; all 212 with M276 experiencing this problem
Last edited by PeterUbers; Nov 3, 2013 at 08:56 AM.
Jerry
Service Campaign 2013090008 OCT13 – MY13 166, X166, 204, X204, 207, 212, 218, 231mbrace software does not correspond to current production configuration, dealer will update. Approximately 47,148 vehicle affected.
Service Campaign 2013090002 NOV13 – MY13 166, X166, 212, 221engine control module does not correspond to production configuration dealer will update software. Approximately 11,715 vehicles affected.
LI54.21-P-057404 OCT13 – 212 VIN A703805 to A736747 image interference in night view system (610), diffused light screen of the night view camera is missing.
LI82.85-P-057407 NOV13 – 117, 166, 172, 204, 207, 212, 218, 246 fuel consumption indicator in system menu is incorrectly scaled or missing, update COMAND control unit software.
LI32.22-P-057569 NOV13 – 212 & 218 Airmatic (489) compressor inoperative, prefuse box is faulty.
Last edited by konigstiger; Nov 11, 2013 at 01:39 PM.
Front noise left side on low speed , dealer was no help
Local shop did inspection , verdict - front struts / or front upper mounts get loose

Asked dealer again to do inspection , success - dealer is going to replace both front struts under warranty
After this checked Bulletins , i think this is a common issue with these cars
LI32.25-P-051123 FEB11 – 212 without Airmatic (489), 207 without vehicle dynamics (483)
dull thumping noises or metallic rattling from the area of the front axle occurring @ speeds 10-45 mph, modified front struts should be installed.
many thanks to konigstiger
will report if issue get fixed70% fixed , still some minor noises
lubed hood mounts , - another 10% fix
after detail inspection found control arm big bushing ( aka trust arm bushings ) loose / fail
dealer is going to replace them next week as well
keep digging if you want to have perfect MB suspension
Last edited by champaign777; Nov 11, 2013 at 03:26 PM.
LI32.25-P-048218: THUMPING NOISES FROM VICINITY OF REAR AXLE
Does anyone have any more info on this? Not even sure if it's applicable to the E63's suspension.
Thanks for any and all help.
Thanks!
052035 not applicable to e63
LI32.25-P-051645 FEB13 - 212.#77 / #74, 221.#74 creaking/squeaking noises from front axle when steering, replace spring cup mountings and suspension strut rubber end stop.
Last edited by konigstiger; Nov 20, 2013 at 04:25 PM.
052035 not applicable to e63
LI32.25-P-051645 FEB13 - 212.#77 / #74, 221.#74 creaking/squeaking noises from front axle when steering, replace spring cup mountings and suspension strut rubber end stop.
Front noise left side on low speed , dealer was no help
Local shop did inspection , verdict - front struts / or front upper mounts get loose

Asked dealer again to do inspection , success - dealer is going to replace both front struts under warranty
After this checked Bulletins , i think this is a common issue with these cars
LI32.25-P-051123 FEB11 – 212 without Airmatic (489), 207 without vehicle dynamics (483)
dull thumping noises or metallic rattling from the area of the front axle occurring @ speeds 10-45 mph, modified front struts should be installed.
many thanks to konigstiger
will report if issue get fixedThanks.
Last edited by tk9; Dec 2, 2013 at 11:52 PM. Reason: Grammar
so far so good now ...
Shock absorbers 2 204-323-30-00 waranty
Dust cap 2 204-323-04-38 waranty
Hydromount 2 204-333-11-14 waranty
Elastomeric cap 4 211-333-06-97 waranty
Bront bearing adjustment both sides DIY
Hood mounts lubed DIY
Last edited by champaign777; Dec 3, 2013 at 09:07 AM.




