oh whaat!?
Thread Starter
Member
Joined: Nov 2009
Posts: 199
Likes: 0
2007 C230 Sport
nice! 
a VERY curious felllaaa here
did u have to cut bumper? or a direct fit ? Some sources say 3mm tape will hold just fine others say some special glue. Yours look very good I am wondering what u used?
Mine should be getting here by tomorrow. I too got the one side as moving the spare wheel hub and everything else is too deep a dive for my swimmin retarded pocket.
a VERY curious felllaaa here
did u have to cut bumper? or a direct fit ? Some sources say 3mm tape will hold just fine others say some special glue. Yours look very good I am wondering what u used?
Mine should be getting here by tomorrow. I too got the one side as moving the spare wheel hub and everything else is too deep a dive for my swimmin retarded pocket.
i honestly like the single side look. and i didn't feel like going through all the trouble to get me the quad setup but doable when i set the funds for that route. gotta get me some rims first =)
MBWorld Fanatic!
Joined: Feb 2009
Posts: 5,054
Likes: 11
From: fort worth, tx
06 C230 SS 6spd
I might get mine soon here in a month, I think i'll look even better if it had three fins instead of two. To get dual exhaust you dont need to move the wheel tub or anything, if that was the case alot of guys on here wouldnt be doing it if it required that much work.
Thread Starter
Member
Joined: Nov 2009
Posts: 199
Likes: 0
2007 C230 Sport
https://mbworld.org/forums/c-class-w...asy-steps.html
here is the tutorial. it's a great tutorial and yes you need to buy those clamps cause trust, you WILL need them!
use epoxy and spread it out evenly around the whole surface and make sure you do this fast cause it starts to bond really quick. i say, you have to finish positioning and mounting within 3 - 4 minutes
