sunroof problems.....
Good luck, hope this works for you.
It sounds as if you might have a pretty bad problem. Unless you do not want to use the sunroof anymore, you will need to spring for it to be done properly.
It worked on my sunroof, hope it works on yours.
It may also be in your owners manual.
It worked on my sunroof, hope it works on yours.
It may also be in your owners manual.
It semed to only do it when I auto-closed the sunroof when it was NOT all the way open...
Took it in, they tested it... Said it was pulling up a couple "error codes..." they cleared them and I haven't had the problem since...
Fortunately covered by the warranty... $95/hr labor is a lot no matter how small of an issue
my sunroof closes automatically, but when i auto open it, it stops in the middle and i have to push the button again. it refuses to auto open all the way. from time to time it also decides to open all the way, mood swings?
dealer says they have to remove the headliner etc...so i didnt bother...
I did the 10 second up and closed and it worked so far. I really didnt test it that much though, but it did close after that. Its the first issue and I hope not many to come. Ive heard all the horror stories with problems.SCARY
. When I bought a MB I thought they would be more reliable
The Best of Mercedes & AMG
I had to hold the button down until the whole thing opened..
My sunroof is acting crazy. The problem changes, and the traditional reset is not working.
Last week: it would close almost all the way and at the last second reverse and stop about 3" open. Try to close and hold - it stops and reverses back to 3" again like something is blocking it. Slide back all the way to hold for reset - no effect. Going forward again reverses itself. Tilt doesn't work either, at all. So I hand crank it back to closed position and leave it there the rest of the week.
Today: I removed the fuse 77 in the right passenger foot area. Put fuse back in. Hit UP. Now it goes up, but it seem too far up, and clicks. Pressing down does nothing. Lubed the joints with a plentiful combo of wd40 and lithium grease. Press down. Now it closes all the way. Holding it back lowers it, forward raises it. One-touch doesn't work. Keep button held back - closes it 2 inches at a time. Keep doing this and it goes all the way - seems like too far, as a hear a couple of clicks - almost like a crunching sound before stopping. All the way forward and up, hold for 10 seconds. Same situation.
All the plastic in there seems fine. At one point the rear tilting window seal thing seemed to be dislodged on the front joints so I put that back into the holes on the sides. So to summarize the current state: it is going too far in either direction, one-click does not work, and going back only goes 2-inches at a time, so you have to keep clicking over and over before it reaches all the way back.
I have no idea now what is causing this, and I can't decide whether to just say the hell with it and stop using it altogether, or keep playing with the damn thing until it corrects itself. The dealership says it needs a new control module, $1200. But I get the feeling they won't seriously troubleshoot it until they have a contract for $1000.
If anyone has experienced this please let me know!








