replacing map and vanity lights???
Thread Starter
Senior Member
Joined: Jul 2004
Posts: 466
Likes: 2
From: Hawaii
2005 Volvo S40 T5 AWD, 2004.5 C230 Sport Sedan, 2005 E320 CDI, 2008 C300 4-Matic Luxury
replacing map and vanity lights???
after calling my dealer, they said that some of the interior lights are difficult to replace and it would require possibly removing some of the headliner and taking some stuff apart. he told me if i wanted to bring it there that he would need it for at least half a day to replace some bulbs 
has anybody replaced the map lights or vanity lights before or know how to? i've tried with no success as the plastic covers just don't seem to want to be pryed off.
has anybody replaced the map lights or vanity lights before or know how to? i've tried with no success as the plastic covers just don't seem to want to be pryed off.
Banned
Joined: Sep 2004
Posts: 189
Likes: 1
From: Delaware, United States. (First ~little~ state)
Mercedes-Benz
Your dealer sounds screwed up... just stick a flat head screw driver in the one side and pull it down. Its EASY! Lets just say, It'll take you no more then a minute to get it out! Can anyone say, the dealership only wants money for a two minute JOB????? I would NEVER go back to them. If I lived in Ohio, I would come over and help you out. I would love to see another C class. hehe
Thread Starter
Senior Member
Joined: Jul 2004
Posts: 466
Likes: 2
From: Hawaii
2005 Volvo S40 T5 AWD, 2004.5 C230 Sport Sedan, 2005 E320 CDI, 2008 C300 4-Matic Luxury
Originally Posted by rockintunes23
Your dealer sounds screwed up... just stick a flat head screw driver in the one side and pull it down. Its EASY! Lets just say, It'll take you no more then a minute to get it out! Can anyone say, the dealership only wants money for a two minute JOB????? I would NEVER go back to them. If I lived in Ohio, I would come over and help you out. I would love to see another C class. hehe
Senior Member
Joined: Sep 2004
Posts: 315
Likes: 2
From: Orlando, FL
2008 E350
Originally Posted by inFiniTE LooP
heh, well while you're absolutely right about my dealer, i think you neglected the second part of my first post. i have already tried to remove the plastic covers (with a flat head screwdriver) and they seriously wont budge. the only ones i've been able to get off like this are the front and rear dome lights, as for the interior trunk light, map lights, glove box light, and vanity lights though, they simply refuse to come out by prying unless you wanna break'em
This should be post #75 for me. I hope this gets me my membership.
GGM
Thread Starter
Senior Member
Joined: Jul 2004
Posts: 466
Likes: 2
From: Hawaii
2005 Volvo S40 T5 AWD, 2004.5 C230 Sport Sedan, 2005 E320 CDI, 2008 C300 4-Matic Luxury
hmph, alrighty, well i guess i'll just have to wait til i need service to get my trunk light installed, you dont by chance know how they did it do you? sneak a peak 
?
?
Senior Member
Joined: Sep 2004
Posts: 315
Likes: 2
From: Orlando, FL
2008 E350
Originally Posted by inFiniTE LooP
hmph, alrighty, well i guess i'll just have to wait til i need service to get my trunk light installed, you dont by chance know how they did it do you? sneak a peak ?
?Hey, LooP, I see you will be a member also in 3 more posts. Congratulations.
GGM
Last edited by GGM; Feb 5, 2005 at 11:37 PM.
Trending Topics
Thread Starter
Senior Member
Joined: Jul 2004
Posts: 466
Likes: 2
From: Hawaii
2005 Volvo S40 T5 AWD, 2004.5 C230 Sport Sedan, 2005 E320 CDI, 2008 C300 4-Matic Luxury
i didn't even realize that until you posted something about it earlier, thanks and congratulations to you as well 
MB World Stories
The Best of Mercedes & AMG
Manual Mercedes? 6 Times Sindelfingen Let Drivers Have All The Fun
Verdad Gallardo
Mercedes SLR McLaren 722 S Is Extremely Rare Example Modified by McLaren
Verdad Gallardo
8 Classic Boxy Mercedes Designs That Have Aged Like Fine Wine
Verdad Gallardo
Flawlessly Restored Mercedes 190E Evo II Heads to Auction
Verdad Gallardo
Electric Mercedes C-Class Unveiled: 11 Things You Need to Know
Verdad Gallardo
Mercedes EQS Gets A Major Update: Everything You Need to Know
Verdad Gallardo
5 Underrated Mercedes-Benz Models That Don't Get the Love They Deserve
Verdad Gallardo
Mercedes 300D Has Pushed Well Past 1 Million Miles and It Ain't Stopping
Verdad Gallardo
10 Most Reliable Mercedes-Benz Models You Can Buy Used
Verdad Gallardo
MBWorld Fanatic!
Joined: Mar 2005
Posts: 1,605
Likes: 0
From: bay area, CA
'06 E350 Iridium Silver with pano
Passenger vanity bulb blew out over the weekend. Has anyone successfully removed the cover without cracking it? I've search for other threads and sounds like it's not as easy as sticking a flat head screwdriver. Any feedback is appreciated. Advanced thanks.
Thread Starter
Senior Member
Joined: Jul 2004
Posts: 466
Likes: 2
From: Hawaii
2005 Volvo S40 T5 AWD, 2004.5 C230 Sport Sedan, 2005 E320 CDI, 2008 C300 4-Matic Luxury
i can feel it start to come out a little bit when i pull on it but haven't had any luck getting the plastic cover off without feeling like it was gonna break. it seems like such a petty thing to go to the dealer for, but if you do end up goin, please post on how they did it or how they told you to replace the bulb 
anyone else have any other thoughts on this?
anyone else have any other thoughts on this?
Thread Starter
Senior Member
Joined: Jul 2004
Posts: 466
Likes: 2
From: Hawaii
2005 Volvo S40 T5 AWD, 2004.5 C230 Sport Sedan, 2005 E320 CDI, 2008 C300 4-Matic Luxury
i figured it out finally, i posted it in another thread but i'll repost it in here since it is more relevant here:
for anyone else that needs to get to these, they WILL come out, it took me a while and some aching fingers, but i finally figured out the easiest way to replace/remove the vanity lights.
1st it depends on which side you're on, driver's side will slide down from the left side and the passenger side is best opened from the right side. both on the sides closest to their respective window.
next, when you begin prying down, if you see metal up there, make sure you DO NOT pull on the metal part, the metal stays up there, once you get a big enough gap to fit something between the metal and the plastic, you need to insert something (between the metal and plastic cover, i just used a quarter (aka $0.25 piece )) and push INSIDE, there is a small thing that goes on an angle almost like a latch, you need to push on this and pull down at the same time to get the cover off and down.
once you've got the cover off, you can push on the black latch connected to the power and the entire thing comes down to replace the bulb (you dont need to do this part to replace the bulb but it sure makes it a heck of a lot easier.)
that's about it, if anybody needs pictures or more detail just ask
for anyone else that needs to get to these, they WILL come out, it took me a while and some aching fingers, but i finally figured out the easiest way to replace/remove the vanity lights.
1st it depends on which side you're on, driver's side will slide down from the left side and the passenger side is best opened from the right side. both on the sides closest to their respective window.
next, when you begin prying down, if you see metal up there, make sure you DO NOT pull on the metal part, the metal stays up there, once you get a big enough gap to fit something between the metal and the plastic, you need to insert something (between the metal and plastic cover, i just used a quarter (aka $0.25 piece )) and push INSIDE, there is a small thing that goes on an angle almost like a latch, you need to push on this and pull down at the same time to get the cover off and down.
once you've got the cover off, you can push on the black latch connected to the power and the entire thing comes down to replace the bulb (you dont need to do this part to replace the bulb but it sure makes it a heck of a lot easier.)
that's about it, if anybody needs pictures or more detail just ask
MBWorld Fanatic!
Joined: Mar 2005
Posts: 1,605
Likes: 0
From: bay area, CA
'06 E350 Iridium Silver with pano
Originally Posted by inFiniTE LooP
i figured it out finally, i posted it in another thread but i'll repost it in here since it is more relevant here:
for anyone else that needs to get to these, they WILL come out, it took me a while and some aching fingers, but i finally figured out the easiest way to replace/remove the vanity lights.
1st it depends on which side you're on, driver's side will slide down from the left side and the passenger side is best opened from the right side. both on the sides closest to their respective window.
next, when you begin prying down, if you see metal up there, make sure you DO NOT pull on the metal part, the metal stays up there, once you get a big enough gap to fit something between the metal and the plastic, you need to insert something (between the metal and plastic cover, i just used a quarter (aka $0.25 piece )) and push INSIDE, there is a small thing that goes on an angle almost like a latch, you need to push on this and pull down at the same time to get the cover off and down.
once you've got the cover off, you can push on the black latch connected to the power and the entire thing comes down to replace the bulb (you dont need to do this part to replace the bulb but it sure makes it a heck of a lot easier.)
that's about it, if anybody needs pictures or more detail just ask
for anyone else that needs to get to these, they WILL come out, it took me a while and some aching fingers, but i finally figured out the easiest way to replace/remove the vanity lights.
1st it depends on which side you're on, driver's side will slide down from the left side and the passenger side is best opened from the right side. both on the sides closest to their respective window.
next, when you begin prying down, if you see metal up there, make sure you DO NOT pull on the metal part, the metal stays up there, once you get a big enough gap to fit something between the metal and the plastic, you need to insert something (between the metal and plastic cover, i just used a quarter (aka $0.25 piece )) and push INSIDE, there is a small thing that goes on an angle almost like a latch, you need to push on this and pull down at the same time to get the cover off and down.
once you've got the cover off, you can push on the black latch connected to the power and the entire thing comes down to replace the bulb (you dont need to do this part to replace the bulb but it sure makes it a heck of a lot easier.)
that's about it, if anybody needs pictures or more detail just ask
