Sensor short circuit
#1
Sensor short circuit
Hi,
I'm getting an engine management light P0546. Two different diagnostic tools gave the same fault code.
1. Exhaust Gas Temperature Sensor Circuit High Code Bank 1 Sensor 1
2. Temperature sensor 1 exhaust system (cylinder bank 1) has a short circuit to positive. There is a short circuit to positive or an open circuit.
I had the sensor replaced. But, the same fault code is showing again after being cleared.
CLS 250 CDI Blue Efficiency 4DR AU
Engine no. 65192430599572
Before I start stripping down to troubleshoot the wire, can anybody tell me where the wire from the sensor goes to?
I'm getting an engine management light P0546. Two different diagnostic tools gave the same fault code.
1. Exhaust Gas Temperature Sensor Circuit High Code Bank 1 Sensor 1
2. Temperature sensor 1 exhaust system (cylinder bank 1) has a short circuit to positive. There is a short circuit to positive or an open circuit.
I had the sensor replaced. But, the same fault code is showing again after being cleared.
CLS 250 CDI Blue Efficiency 4DR AU
Engine no. 65192430599572
Before I start stripping down to troubleshoot the wire, can anybody tell me where the wire from the sensor goes to?
#2
Member
If I recall I used that connector to heck the signal to the coil with an old dwell meter. I will check it to be sure it is tight. On the issue of maintenance costs to be truthful I rarely had anythng to do with this car while my husband was alive. He looked after all the care of vehicles and other equipmenand I don't know what he might have replaced. I am really new at this crar maintenance and it has been a steep learning curve but thanks to you it has been easier than I ever imagined.