Robperri

Measurement up from molding and door crease? I want to mount it exactly right..

kblair3d

this may be a redic question but is there a particular place it needs to be put on (height wise) it looks as if its running in the middle of the fender seam on the quarter panel .

kblair3d

funny I didnt see this thread... did you find out the answer?

Robperri

Not Really. What I ended up doing was finding a picture of a CLK63 (I have a CLK55) with a 6.3 badge on the side. I cropped and cropped and printed and reprinted until I had a printed picture that lined up with the molding and fender of my car and then used that as a template. It worked! I know...

kblair3d

lol sometimes we have to figure things out and hope it works, I did the same with one of the vents with my other car till I said there is no way Im doing this then brought it into the shop to have it done... I couldnt bother.
It just looks as if its in the midde of the fender seam to me

Robperri

kblair3d

looks like a 2 finger spacing to me from the fender in and 1/2 way down

Robperri

S550 right?





make sure its parallel to the chrome strip on the bottom