C32 Custom Dual Exhaust and Diffuser
10-03-2010, 08:47 PM
#26
Member
Join Date: Feb 2009
Location: Denver, CO
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
C32
Just had to chime it on this one. Looks great. I kind of wished you had not of done it because I already talked myself out of going for it but now that I see the finished product...wow. Next time I'm in Houston I'll take you up on your offer. (applause)
10-03-2010, 10:06 PM
#27
MBWorld Fanatic!
Join Date: Jul 2007
Location: Livingston, California.
Posts: 1,013
Likes: 0
Received 0 Likes
on
0 Posts
2002 c32 AMG 2012 c250 Coupe
Sounds great and looks awsome.. Something that many have considered and not accomplished.. Props to you my friend..
10-04-2010, 10:45 AM
#32
Senior Member
Join Date: Nov 2007
Location: Snellville, GA
Posts: 358
Likes: 0
Received 1 Like
on
1 Post
'03 C32, '08 ML63
I've been thinking about putting dual exhaust on mine. I thought I remembered reading that you had to change the spare tire dish over to the one from the CLK. Is that right? Or did you just route around the spare tire? I can't quite tell from the pics.
Very nice install though, I like it.:
Very nice install though, I like it.
:
10-04-2010, 11:45 PM
#34
10-05-2010, 07:55 AM
#35
Super Member
Thread Starter
They look the same, I bought mine from this guy.
http://cgi.ebay.com/ebaymotors/BENZ-...Q5fAccessories
The quality was pretty good compared to some other ones I've seen. It's got some bulk to it and isn't at all flimsy.
http://cgi.ebay.com/ebaymotors/BENZ-...Q5fAccessories
The quality was pretty good compared to some other ones I've seen. It's got some bulk to it and isn't at all flimsy.
10-05-2010, 02:54 PM
#36
They look the same, I bought mine from this guy.
http://cgi.ebay.com/ebaymotors/BENZ-...Q5fAccessories
The quality was pretty good compared to some other ones I've seen. It's got some bulk to it and isn't at all flimsy.
http://cgi.ebay.com/ebaymotors/BENZ-...Q5fAccessories
The quality was pretty good compared to some other ones I've seen. It's got some bulk to it and isn't at all flimsy.
10-05-2010, 03:30 PM
#37
Super Member
Thread Starter
I had to cut the second exhaust port out but I just clamped the diffuser in place and traced the opening with a dry erase marker. Used a Dremel with a cutting disc and bam, less than a minute later it was there. Smoothed it out with a sanding wheel on the Dremel and headed to the exhaust shop. They would have done it there as I assume most shops will but I had the tools. For installation I used 3M double sided ultra strength automotive tape on the entire back side and then clamped it on with 5 clamps to hold it for an hour. I ran a bead of black epoxy along the top and side edges after it was on just for good measure. I need to touch up the epoxy again but overall it's holding just fine.
10-08-2010, 11:44 PM
#38
Super Member
LOOKS AND SOUNDS GREAT!!!!! drive by sound clip
PLEEEEEEEEEEEEEAAAAAAAAAASE!!!!!!
11-29-2010, 08:21 AM
#40
Super Member
Thread Starter
This is the only rolling video I have right now but you can hear the exhaust for sure.
http://www.youtube.com/watch?v=mjrT9m0jMx8
You can see it again here at about 2:00
http://www.youtube.com/watch?v=k0zOkWJ-YxA
http://www.youtube.com/watch?v=mjrT9m0jMx8
You can see it again here at about 2:00
http://www.youtube.com/watch?v=k0zOkWJ-YxA
11-29-2010, 02:26 PM
#41
MBWorld Fanatic!
Join Date: Nov 2006
Location: California, USA
Posts: 9,137
Likes: 0
Received 4 Likes
on
4 Posts
E63 P30, CL500 Sport
Great project, the dual exhaust looks so much better on the C32 and it really should've came like that from the factory 
Regarding the diffuser, I think I would've went with 3 fins but it still does the job I think
Regarding the diffuser, I think I would've went with 3 fins but it still does the job I think
