hey guys my power steering pump just went bad and need to replace it. does anyone have a diy write up on the removal and install. thanks
Senior Member
johnhef
Senior Member
close
Oct 28, 2020
It should be fairly straight forward, I don't have my 32 in front of me to see if its the same but pretty much every other 112/113 engine its this way:
remove the power steering reservoir first, theres one E10 bolt up top and a C clip at the pump inlet.
take a punch and depending if your belt tensioner has a center E10 on the pulley (old style) or 17mm fixed nut under the pulley (new style) release the tension and lock the tensioner with the punch or a small pin.
remove the belt from your pump.
usually one bolt on the backside of the pump, E12 remove it first, a ratcheting 10mm wrench can come in handy here.
remove the two front E12's last.
installation is reverse of removal. start all three bolts in the pump first before tightening them.
remove the power steering reservoir first, theres one E10 bolt up top and a C clip at the pump inlet.
take a punch and depending if your belt tensioner has a center E10 on the pulley (old style) or 17mm fixed nut under the pulley (new style) release the tension and lock the tensioner with the punch or a small pin.
remove the belt from your pump.
usually one bolt on the backside of the pump, E12 remove it first, a ratcheting 10mm wrench can come in handy here.
remove the two front E12's last.
installation is reverse of removal. start all three bolts in the pump first before tightening them.
