Project CLK32K
Def Subscribing to this one.
Do you have to do anything special to the trans/tq convertor/rear end for this added hp/tq?
Agreed on debadge look....... I love sleepers and have had a few in my day.
Good luck with this project.
After a bit of searching I found the few key components that I needed to get the ball rolling. I ordered them and most of the OEM and upgraded parts.
Since I last posted here I learned that Eurocharged is no longer making any of their headers. Jake and Jerry at EC have been very helpful and honest.
I was preparing myself to spend $2k on a set of Kleeman headers, Jerry advised me to wait a bit and he could probably source me a set. I wouldn't mind getting my hands on a used EC set. If the summer approaches and I haven't had any luck I will go Kleeman.
Here is a list of the parts and mods that were ordered. I also have the E55/SL55 airbox that I will be using. Once everything comes in I will be dropping the car off, shooting for the end of the month.
C32 ECU, EIS, key, alternator, power steering pump, ac compressor, timing cover, and engine wiring harness < This one hurt cuz I had to buy it new
.Eurocharged 185mm Pulley & Tune
Eurocharged Heat Exchanger
Johnson CM30 IC Pump
Needswings Pulley Saver Kit
Needswings IC Isolation kit
NSK SC Bearing
NGK Iridium one step colder plugs
Magnecor KV85 8.5mm wires
Last edited by dynomite05; Mar 9, 2011 at 10:57 AM.
The Best of Mercedes & AMG
Thanks brother. I have been lurking around the C32 forum for a few months now and have learned a lot from you guys. I will be posting a thread there as soon as I have the motor in.




...










