CLK55 AMG, CLK63 AMG (W208, W209) 2000 - 2010 (Two Generations)

OK , I Broke it !

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 12-30-2011 | 09:03 AM
  #1  
PTE's Avatar
PTE
Thread Starter
MBWorld Fanatic!
 
Joined: Jul 2005
Posts: 1,224
Likes: 6
From: S.E. FLA.
05 ML-500 , 03 CLK5.5 AMG has left the Garage
OK , I Broke it !

Last week somebody left Diesel fuel on the track from the 1/8 th mile to the Turn off. I got into the spill and the wheels broke loose & the car started to slide to the right. The active handling really works. It help me get the car back under control. This was the first time I ever tried it , I always was using the dyno mode up to this run , I tried sport mode with the ESP switch on just to see if I could improve the time.. Here is the U-tube , many thanks to Urbamorm

http://www.youtube.com/watch?v=z9dUv...ature=youtu.be

Well This week I went back at it again. This time there was a 2-1/2 hr wait for a track clean up. I was close to the end in a long line of cars . Needless to say Water ended up on the track , At the 60 ' mark the tires broke loose . Then re-hooked . BANG broke the C/V joint . It was a long night & A ride home on the Flat bed. Picture are coming .
Cheers _PTEngineering

Last edited by PTE; 12-30-2011 at 07:57 PM.
Old 12-30-2011 | 11:08 AM
  #2  
betrezra's Avatar
MBWorld Fanatic!
 
Joined: Nov 2009
Posts: 3,589
Likes: 68
From: Texas
C63 507 AMG DA Car #19
Glad you are OK!
I've seen cars go into the wall at the track, and it's not pretty..... especially in something built from unobtainium
Old 12-30-2011 | 01:29 PM
  #3  
PTE's Avatar
PTE
Thread Starter
MBWorld Fanatic!
 
Joined: Jul 2005
Posts: 1,224
Likes: 6
From: S.E. FLA.
05 ML-500 , 03 CLK5.5 AMG has left the Garage
OK, I broke it ,Pictures

Hey Ahmad , looks familiar
Cheers _PTEngineering
Attached Thumbnails OK , I Broke it !-axel-1.jpg   OK , I Broke it !-axel-2.jpg   OK , I Broke it !-axel-3.jpg  
Old 12-30-2011 | 03:44 PM
  #4  
betrezra's Avatar
MBWorld Fanatic!
 
Joined: Nov 2009
Posts: 3,589
Likes: 68
From: Texas
C63 507 AMG DA Car #19
What material is that?
Old 12-30-2011 | 10:19 PM
  #5  
2MCHCAR's Avatar
MBWorld Fanatic!
 
Joined: May 2008
Posts: 1,238
Likes: 17
From: Los Angeles, CA
Supercharged CLK500 & ML500
Glad it wasn't a total disaster and that your okay!

I'm curious on how much ET did you lose by keeping the ESP on. I always fear running on Dyno Mode since you don't have the safety nets (ESP, ABS, Traction Control). I'll sacrifice a tenth or two for peace of mind.
Old 12-31-2011 | 08:13 AM
  #6  
PTE's Avatar
PTE
Thread Starter
MBWorld Fanatic!
 
Joined: Jul 2005
Posts: 1,224
Likes: 6
From: S.E. FLA.
05 ML-500 , 03 CLK5.5 AMG has left the Garage
Oh , I Broke it

I don't no yet, I have not completed a full pass with out an issue. I believe that I will not loose any speed or increase my ETs. Andy @ Modern Hp, set up the TCU to remove the torque limiters & raise the shift point rpm ,in Sport mode with the ESP switch activated Only . All is normal in Comfort mode & Sport mode when driving the streets & Hwy.
I got the old broken half shaft assy out in 2 hrs. new one on the way
Cheers _PTEngineering
Old 12-31-2011 | 08:32 AM
  #7  
Lenin's Avatar
MBWorld Fanatic!
 
Joined: Mar 2004
Posts: 2,073
Likes: 27
From: North NJ
2002 C32 AMG, 2013 GLK 350/4, 2015 E63S AMG Wagon
What tire pressure were you running at the time?
Old 12-31-2011 | 09:03 AM
  #8  
Kevwood's Avatar
MBWorld Fanatic!
 
Joined: Jul 2010
Posts: 4,748
Likes: 0
From: A Canadian in Dubai, United Arab Emirates
'05 C200K SS, '05 Kleemann CLK500K, '08 Hummer H3 & '92 Z34 5sp (track car in Canada)
Snapped a few of them in my time back home, a Chevy part is far cheaper than a MB one I imagine though!
Old 12-31-2011 | 09:16 AM
  #9  
Chappy's Avatar
MBWorld Fanatic!
 
Joined: Jul 2002
Posts: 9,731
Likes: 63
From: Hotlanta
AMG
Exhaust sounds sweet!
Old 01-01-2012 | 04:13 AM
  #10  
cobrab19's Avatar
Junior Member
 
Joined: Nov 2010
Posts: 68
Likes: 1
2003 clk 55
hey pte ive been trying to get ahold of u regarding the bs swaybar to fit in my 03 clk55. i even made a thread about it,you and dynomite are the ONLY ones who can help and i cannot get ahold of dyno right now...

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 


You have already rated this thread Rating: Thread Rating: 0 votes,  average.

Quick Reply: OK , I Broke it !



All times are GMT -4. The time now is 06:14 PM.