Issues on my C218 2012 CLS350 after windows tinted
Thread Starter
Newbie
Joined: Apr 2022
Posts: 1
Likes: 0
CLS350 W218
Issues on my C218 2012 CLS350 after windows tinted
Hello Guys,
I faced those issues after titned my car windows. The issues are:
Error codes:
Regards,
I faced those issues after titned my car windows. The issues are:
- No reverse lights
- Camera not working
- No Signal rear lights
- Trunk release not working
- Fuel level gauge not working
- Diffeuser light always on
- Light switch not working and all lights are on once I open ignition
- etc
Error codes:
- U011100
- U011187
- U014600
- 474F00
- A3A813
- U014200
- U14287
- 510808
Regards,
Junior Member
Joined: Mar 2022
Posts: 21
Likes: 7
From: CA
2012 CLS 550
This doesn't really make sense, tinting the windows should NOT do that lol.
As rick said, did you remove any door panels or anything electrical or mess with anything like that?
Perhaps some of the water from the tinting process (or whatever liquid it is) seeped into the door panels and messed up some of the electronics. If that's the case, it's gonna be an expensive fix. Hope you can get the tint shop to accept liability if that ends up being your issue.
As rick said, did you remove any door panels or anything electrical or mess with anything like that?
Perhaps some of the water from the tinting process (or whatever liquid it is) seeped into the door panels and messed up some of the electronics. If that's the case, it's gonna be an expensive fix. Hope you can get the tint shop to accept liability if that ends up being your issue.
Last edited by kemofei; Apr 30, 2022 at 11:01 PM.
Member
Joined: Oct 2020
Posts: 223
Likes: 82
From: Phoenix, AZ
2013 Weistec 540/715 tuned CLS 550, 2008 E350, and '07 Jaguar S-Type R
I'm betting it's a low voltage issue since they likely had the doors open for a while. Many modern cars are very sensitive to voltage - my wife's Jag accessories start going haywire at anything below 12. 3volts. The battery tests fine but needs to be replaced.
