Driveshaft Recall
#31
Member
Joined: Feb 2016
Posts: 223
Likes: 144
From: Canada
AMG GT-S, AMG C43, GLK350, Nissan GT-R, 718 Cayman
I'm in Canada. I just got my letter dated Aug 12 2019 for my 2016 GT-S for the driveshaft recall. Car ordered Dec 31st 2015, received May 5 2016. They must have expanded the recall numbers, as original MB docs said it was only a limited number of cars. No parts available yet said my dealer, and I am supposed to wait for a second letter.
#32
Junior Member
Joined: Jul 2020
Posts: 23
Likes: 2
From: Venice, FL
AMG GTS, Mercedes CLS450, Porsche Cayenne, Chevrolet Corvette
I bought my 2016 GTS a few weeks ago and the CARFAX report flagged this recall issue as not being fixed. So, I'm getting it looked at next week - supposedly a 2 hour inspection is required. Given car has 10k miles, I suspect they won't see any issues. If they do, how long does the dealer take to do this service? Given its potentially a safety issue, I could see them giving me a service car until its repaired.
#33
[They have to check the serial number on your tourqe tube. Or drive shaft to people in the US. If they have to swap it out it is pretty extensive time wise. Almost everything under the car comes out.. so yes they should give you a loaner because it is a recall and it takes a long time to repair.
QUOTE=FloridaGTS;8109534]I bought my 2016 GTS a few weeks ago and the CARFAX report flagged this recall issue as not being fixed. So, I'm getting it looked at next week - supposedly a 2 hour inspection is required. Given car has 10k miles, I suspect they won't see any issues. If they do, how long does the dealer take to do this service? Given its potentially a safety issue, I could see them giving me a service car until its repaired.[/QUOTE]
QUOTE=FloridaGTS;8109534]I bought my 2016 GTS a few weeks ago and the CARFAX report flagged this recall issue as not being fixed. So, I'm getting it looked at next week - supposedly a 2 hour inspection is required. Given car has 10k miles, I suspect they won't see any issues. If they do, how long does the dealer take to do this service? Given its potentially a safety issue, I could see them giving me a service car until its repaired.[/QUOTE]
#35
Junior Member
Joined: Jul 2020
Posts: 23
Likes: 2
From: Venice, FL
AMG GTS, Mercedes CLS450, Porsche Cayenne, Chevrolet Corvette
Unfortunately, after a brief inspection today, my 2016 GTS (VIN GA005495) requires the driveshaft to be replaced. Estimated time to repair is 1 week. Given the extensive amount of work to do this job, not too happy about this. Fear there will be some side affects.
#36
Don't worry. Mine was done and I have not had a single issue with it since..
#38
Mine is part of the recall and has close to 40K miles on it. all of these separation of the driveshaft happened in early miles. If you are low miles do it. I am in no rush to do mine.
#39
Be careful about that. It does seem true that most fail at low miles....but mine also failed at low miles out in the middle of no where! I had to wait 2 hours for a tow truck. It wasn't fun.
The following users liked this post:
UCIMBZ (07-28-2020)
#40
Super Member
Joined: Sep 2017
Posts: 988
Likes: 680
From: Santa Monica Mountains
2020 GTA; 2022 Audi e-tron GT, 2022 Ford F-150; 1926 Rolls-Royce Springfield 40/50 Playboy roadster
My recall involves putting some label on the engine. My dealer has been urging me to bring the car in for that. But says it will only take half a day.
I've told the dealer I'll get that very important recall work done when I get an oil change. And to stop calling me about the recall.
I've told the dealer I'll get that very important recall work done when I get an oil change. And to stop calling me about the recall.
The following users liked this post:
JSwan724 (07-28-2020)
#41
Junior Member
Joined: Jul 2020
Posts: 23
Likes: 2
From: Venice, FL
AMG GTS, Mercedes CLS450, Porsche Cayenne, Chevrolet Corvette
Just got my car back from this recall. It was at the dealer for a week but most of that time was waiting on the parts. Once parts arrived, it took about 1 day to complete. Drive shafts with tags between 000322 and 002635 need to be replaced. The dealer charged the 'mother ship MB corporation' $3500 to do this work. Had I needed to pay this out of pocket, scary to think how much they would have charged.