How much boost do the new cdi motors make?
#1
Almost a Member!
Thread Starter
Join Date: Jan 2007
Location: Atlanta, GA
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
08 ML320CDI
How much boost do the new cdi motors make?
Just as the title says... How much boost do the new cdi motors make?
Has anyone hooked a boost guage an verified?
Does anyone know what kind of EGT's these motors run at full tilt?
Just wondering how conservative the factory tune is. (or how much is left on the table)
Thanks
Dieselfan
Has anyone hooked a boost guage an verified?
Does anyone know what kind of EGT's these motors run at full tilt?
Just wondering how conservative the factory tune is. (or how much is left on the table)
Thanks
Dieselfan
#4
Super Member
Join Date: Dec 2001
Location: Northern California
Posts: 672
Likes: 0
Received 0 Likes
on
0 Posts
MBs
Yes, pretty conservative, like would be expected of a Mercedes-Benz engine.
2.0 bar or 29 psi
Some articles which mention it:
http://www.trucktrend.com/roadtests/...s_benz_320_cdi
http://www.dieselpowermag.com/news/0...es_diesel.html
2.0 bar or 29 psi
Some articles which mention it:
http://www.trucktrend.com/roadtests/...s_benz_320_cdi
http://www.dieselpowermag.com/news/0...es_diesel.html
#5
Banned
Join Date: Apr 2006
Location: Federal Heights, CO
Posts: 1,116
Likes: 0
Received 3 Likes
on
3 Posts
1982 300D VNT, 1980 240D 3.0T, 1982 300TD
29psi?
Still, that's higher than I thought it would be. I was thinking it was around 20psi.
How about the Sprinter's 2.7L engine, what is the boost on it?
How about the Sprinter's 2.7L engine, what is the boost on it?
#6
Almost a Member!
Thread Starter
Join Date: Jan 2007
Location: Atlanta, GA
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
08 ML320CDI
2bar or 29.4 lbs. is fairly high (stock). I also am suprised that it is that high. I is a small motor though so they must need the boost to make the #'s. I am sure it will be a little while but I would love to stick a fueling computer on this thing and up the boost. I imagine that 275-290 hp / 500-550 lb/ft wouldn't be too hard to achieve.
I would love an outlook monitor now on the vehicle to see all the sensors. I would love to watch in realtime the EGT's, Boost, Trans temps etc.
Anyone know of a way to see these #s without going the route of installing mechanical sending units, are there sensors on this vehicle that one could intercept thru the OBD ports or something like they do on 3/4ton domestic diesels?
Dieselfan
I would love an outlook monitor now on the vehicle to see all the sensors. I would love to watch in realtime the EGT's, Boost, Trans temps etc.
Anyone know of a way to see these #s without going the route of installing mechanical sending units, are there sensors on this vehicle that one could intercept thru the OBD ports or something like they do on 3/4ton domestic diesels?
Dieselfan