GL350 X166 Oil Filter Housing Issue (OM642)
Did any of you experienced the same issue? Are there any X166 GL350 owners here that can share their part number and maybe a pic of the oil housing part number installed on their GL350 (the part # is printed on the connecting aluminum tube and easy to find)?
Thank you all.




The mid-seals are available.
https://www.idparts.com/oil-filter-flange-mid-gasket-om642-6421801410-01681100-p-14975.html
https://www.idparts.com/oil-filter-flange-gasket-set-om642-6421840080-77026800-p-14981.html
Last edited by kajtek1; Dec 9, 2021 at 10:52 AM.
The leak is from the middle seal, which I believe I can change it myself. I have the tools, but I don't know if a lot of oil will start coming out. Will do some research first.
Thank you,
LL




I did the job few years back and don't recall it being difficult, but I keep my engines clean all the time and I washed the oil residue before doing the job.
The pic below shows the gasket I need to replace.
So just to make sure I understand correctly. If I open the filter housing top, and let it sit for 1-2 hours, the oil will drip down to the crankcase and then I will be able to separate the two parts without having oil coming out and without having to drain the engine oil from the bottom oil drain plug. Is that correct?
Thank you


