I turn the car on and it turns right off and then it works good
#1
Super Member
Thread Starter
I turn the car on and it turns right off and then it works good
On my E320, I turned the car on and it just died right away, did the same thing for 2 more times and then it went fine. No issues after that, any thoughts?
#2
MBWorld Fanatic!
Was
the car warmed up when you tried to start it?Like had you parked and gone into a store and came out and it did this?
what year e320?
ohlord
what year e320?
ohlord
#3
Super Member
Thread Starter
yes, car warmed up. Its a 98 E320, never happened before. I drove it to the store, came back in about a couple of min and it did it 3 times and then was all fine.
#4
MBWorld Fanatic!
I'm not a mind reader,
If you were wondering how I knew that chain of events.....
CPS
Crankshaft position sensor.....common symptoms point to that.Car is warmed up it stalls or won't start,you wait 15 minutes starts right up
part is about 60-80 bucks(depends on production date of the car) at
http://www.autohausaz.com/search/pro...ition%20Sensor
the best place to get parts or one of a few best places
and the diy takes a bit of climbing under the hood with a good flashlight but is not that hard to remove and replace if you are a diy type of owner.
http://www.mercedesshop.com/Wikka/M112M113CPS
and another diy in the diy section of benzworld.org w210 diy section.
ohlord
CPS
Crankshaft position sensor.....common symptoms point to that.Car is warmed up it stalls or won't start,you wait 15 minutes starts right up
part is about 60-80 bucks(depends on production date of the car) at
http://www.autohausaz.com/search/pro...ition%20Sensor
the best place to get parts or one of a few best places
and the diy takes a bit of climbing under the hood with a good flashlight but is not that hard to remove and replace if you are a diy type of owner.
http://www.mercedesshop.com/Wikka/M112M113CPS
and another diy in the diy section of benzworld.org w210 diy section.
ohlord
Last edited by ohlord; 04-30-2008 at 12:06 PM.
#7
Super Member
Thread Starter