2006 mb e350 diagnostic code 0756 b6/5
#1
Newbie
Thread Starter
2006 mb e350 diagnostic code 0756 b6/5
i recently replaced my balance shaft as well as the chain guides, the oil pump, both rear and front main seals. this work was done by myself along with another friend who is also a mechanic. now i am geting a code 0756 b6/5 current intake camshaft and hall sensor (the time of the signal value is implausible could this be related only to the sensor because everything was done internally the right way all marks were lined up can someone please help
#2
Out Of Control!!
Well if I were you and once the snow melts find someone very capable in the use of DAS Xentry. Have him do the guided tests sequence asociated with answering your sensor/balance shaft question----it will be worth the cost to determine wether in fact it is a faulty right side intake hall sensor(b6/5), another sensor in the ME electronics or the worst!! Good Luck
#3
Newbie
Thread Starter
would that be covered under the 1 hr diagnostics fee? i stress again the timing seems right the car cranks and starts but than stalls within a few seconds
#4
Out Of Control!!
Should be!!, but ask you tech friend, 5 minutes to wash hands, 10 minutes to take a wiz, 10 minutes to talk to the lead teck, 10 minutes to hook up------wada you think!!
#6
Newbie
Thread Starter
172,000 valves and cylinder pass compression testing timing seems right car cranks and starts and than stalls mb code 0756 b6/5 right intake camshaft position hall sensor is the only code coming up (generic code po341)
Trending Topics
#10
Newbie
Thread Starter
ok so i fixed that problem it was the right intake camshaft sensor but the car still cranks starts for a little bit longer and than stalls but now code po336 comes up regarding crank shaft sensor but i replaced that right before the balance shaft went. could the sensor be damaged and need to be replaced again ? what do you guys think