Code 5503, no leaks rebuilt compressor
#1
Junior Member
Thread Starter
Code 5503, no leaks rebuilt compressor
Hi
Im out of ideas, I checked all shocks with spraying soap water I rebuilt my air compressor with kit from ebay(new gasket and piston ring) and a removed my airtank in trunk and drowned it in pool of water - no leaks anywhere.
all I havnt’ checked is the relay for pump.
when I use my i980 icarsoft to monitor airmatic pressur sensor, as soon as I go into suspension > actual values, this command stop the function of the compressor. As soon as I leave the suspension menu the pumps starts again. So therefor I can get a accurate reading (takes about 5 sec from it stops to my scanner to load 2 menus. But when I do this I get 7 bar from B7 airmatic pressure sensor. But I suspect this value is higher because of my scanner as i described.
car sits fine I dont see any corners ever going down
Im out of ideas, I checked all shocks with spraying soap water I rebuilt my air compressor with kit from ebay(new gasket and piston ring) and a removed my airtank in trunk and drowned it in pool of water - no leaks anywhere.
all I havnt’ checked is the relay for pump.
when I use my i980 icarsoft to monitor airmatic pressur sensor, as soon as I go into suspension > actual values, this command stop the function of the compressor. As soon as I leave the suspension menu the pumps starts again. So therefor I can get a accurate reading (takes about 5 sec from it stops to my scanner to load 2 menus. But when I do this I get 7 bar from B7 airmatic pressure sensor. But I suspect this value is higher because of my scanner as i described.
car sits fine I dont see any corners ever going down
Last edited by larsk84; 09-12-2021 at 10:48 AM.