Bulletins 207 coupe & 212 sedan
#51
Out Of Control!!
Join Date: Jun 2008
Location: Earth
Posts: 10,557
Likes: 0
Received 18 Likes
on
18 Posts
Porsche Macan S SportDesign / Ex M-B's: 11 & 10 & 06 E350's, 02 S500
If this is what I'm thinking of, most new E's had it when I got my 2011, including mine to a slight extent. Mine is a 3/11 build date.
#52
Out Of Control!!
Thread Starter
Join Date: Jul 2003
Location: North Scottsdale, AZ
Posts: 15,903
Received 4,446 Likes
on
3,154 Posts
'71 Pinto
Regardless of JAN11 notation, I would have bumper checked.
#53
Out Of Control!!
Thread Starter
Join Date: Jul 2003
Location: North Scottsdale, AZ
Posts: 15,903
Received 4,446 Likes
on
3,154 Posts
'71 Pinto
Recall 2011110002 JAN12 – 2011 164, 164.8, 212 and 251 check diesel fuel filter replace if necessary. Due to the variations in the materials used by supplier filter may develop leaks. Approximately 6,784 vehicles affected.
LI67.30-P-050613 - 212 up to VIN A519818 front door windows intermittently reverse direction when closing cause excessive resistance dealer will replace and align window under warranty.
LI68.10-P-050415 - 212 burl walnut trim that is fading or discoloring and VIN is between A000988 to A291888 cause inadequate UV protection dealer will replace all trim under warranty.
LI67.30-P-050613 - 212 up to VIN A519818 front door windows intermittently reverse direction when closing cause excessive resistance dealer will replace and align window under warranty.
LI68.10-P-050415 - 212 burl walnut trim that is fading or discoloring and VIN is between A000988 to A291888 cause inadequate UV protection dealer will replace all trim under warranty.
Last edited by konigstiger; 02-07-2012 at 02:02 PM.
#54
Super Member
Join Date: May 2010
Location: Chicago and NorCal
Posts: 519
Likes: 0
Received 2 Likes
on
2 Posts
Titleist
Hi Konigstiger,
For:
LI68.10-P-050415 - 212 burl walnut trim that is fading or discoloring and VIN is between A000988 to A291888 cause inadequate UV protection dealer will replace all trim under warranty.
Is the issue and replacement limited to the serial range provided? I have an A31xxxx and the burl trim above the glove box is considerably faded as compared to the adjacent trim. Could there be a few outside the range with the issue?
Thanks in advance.
For:
LI68.10-P-050415 - 212 burl walnut trim that is fading or discoloring and VIN is between A000988 to A291888 cause inadequate UV protection dealer will replace all trim under warranty.
Is the issue and replacement limited to the serial range provided? I have an A31xxxx and the burl trim above the glove box is considerably faded as compared to the adjacent trim. Could there be a few outside the range with the issue?
Thanks in advance.
#55
Out Of Control!!
Thread Starter
Join Date: Jul 2003
Location: North Scottsdale, AZ
Posts: 15,903
Received 4,446 Likes
on
3,154 Posts
'71 Pinto
Regardless of VIN dealer should replace any discolored wood trim under factory warranty without question. You can reference DTB to justify a claim to replace all trim if you have concern that new piece may not match remaining trim.
#56
Out Of Control!!
Join Date: Jun 2008
Location: Earth
Posts: 10,557
Likes: 0
Received 18 Likes
on
18 Posts
Porsche Macan S SportDesign / Ex M-B's: 11 & 10 & 06 E350's, 02 S500
Hi Konigstiger,
For:
LI68.10-P-050415 - 212 burl walnut trim that is fading or discoloring and VIN is between A000988 to A291888 cause inadequate UV protection dealer will replace all trim under warranty.
Is the issue and replacement limited to the serial range provided? I have an A31xxxx and the burl trim above the glove box is considerably faded as compared to the adjacent trim. Could there be a few outside the range with the issue?
Thanks in advance.
For:
LI68.10-P-050415 - 212 burl walnut trim that is fading or discoloring and VIN is between A000988 to A291888 cause inadequate UV protection dealer will replace all trim under warranty.
Is the issue and replacement limited to the serial range provided? I have an A31xxxx and the burl trim above the glove box is considerably faded as compared to the adjacent trim. Could there be a few outside the range with the issue?
Thanks in advance.
#57
Newbie
Join Date: Nov 2010
Location: Northeast Ohio & SW FO
Posts: 14
Likes: 0
Received 1 Like
on
1 Post
2019 - S560 4Matic (designo Cashmere White Magno (matte finish) & 2013 - S550 4Matic (Andorite Grey)
Picture of the faded Trim in my 2010. Emailed my dealer the pics this AM and asked him to get back to me with the date he wanted to schedule to replace all the trim - being replaced this Thursday.
#59
Out Of Control!!
Join Date: Jun 2008
Location: Earth
Posts: 10,557
Likes: 0
Received 18 Likes
on
18 Posts
Porsche Macan S SportDesign / Ex M-B's: 11 & 10 & 06 E350's, 02 S500
WOW! That looks awful. Does your car sit in the sun a lot? Reason that I ask is because my car doesn't bake in the sun too often, and I have tinted windows which I wonder mask the effect of fading the wood. However, now that I see it, there's no doubt that my eyes aren't playing any tricks on me.... my cars wood has not faded at all, and it very colorful/full looking.
#61
Out Of Control!!
Thread Starter
Join Date: Jul 2003
Location: North Scottsdale, AZ
Posts: 15,903
Received 4,446 Likes
on
3,154 Posts
'71 Pinto
LI46.20-P-053398 – Rattling/thumping noises from area of steering, possible cause excessive play between thrust piece and steering rack.
LI88.20-P-053415 – s212 (wagon) & 218 (CLS) Rear bumper sticks out in area of rear lamp, cause too much play between bracket for bumper and lamp. Thermal expansion causes the bumper to stick out, protective fill is installed to correct this.
LI82.10-P-053439 – “High Beam Assist nonfunctional” message, replace multi function camera and calibrate.
LI88.20-P-053415 – s212 (wagon) & 218 (CLS) Rear bumper sticks out in area of rear lamp, cause too much play between bracket for bumper and lamp. Thermal expansion causes the bumper to stick out, protective fill is installed to correct this.
LI82.10-P-053439 – “High Beam Assist nonfunctional” message, replace multi function camera and calibrate.
Last edited by konigstiger; 04-14-2012 at 03:19 PM.
#62
Newbie
Join Date: Nov 2010
Location: Northeast Ohio & SW FO
Posts: 14
Likes: 0
Received 1 Like
on
1 Post
2019 - S560 4Matic (designo Cashmere White Magno (matte finish) & 2013 - S550 4Matic (Andorite Grey)
Generally had the slider pushed in. Dealer replaced all the wood. It was a factory defect; bad batch of UV protection.
Side note: given the many issues I have had with this vehicle, dealer and M-B replaced my 2010 with a new 2012! A HUGE show of unbelievable customer support that has endeared me to both forever. This is why M-B is #1 in customer retention. Forget the horror stories you read; work with them in a reasonable, professional manner and good things happen. The 2012 is sooooo sweet!!!
Side note: given the many issues I have had with this vehicle, dealer and M-B replaced my 2010 with a new 2012! A HUGE show of unbelievable customer support that has endeared me to both forever. This is why M-B is #1 in customer retention. Forget the horror stories you read; work with them in a reasonable, professional manner and good things happen. The 2012 is sooooo sweet!!!
#63
Out Of Control!!
Thread Starter
Join Date: Jul 2003
Location: North Scottsdale, AZ
Posts: 15,903
Received 4,446 Likes
on
3,154 Posts
'71 Pinto
#64
http://www.allworldauto.com/tsbs/NHT...in_375901.html
I find when I accelerate, from stop the vechile gives a slight jerk. I'm not sure if it's my driving style though!
any idea of that service bulletin will affect me ; 2011 E250.
What does RM UPDATED mean?
I find when I accelerate, from stop the vechile gives a slight jerk. I'm not sure if it's my driving style though!
any idea of that service bulletin will affect me ; 2011 E250.
What does RM UPDATED mean?
#65
Out Of Control!!
Thread Starter
Join Date: Jul 2003
Location: North Scottsdale, AZ
Posts: 15,903
Received 4,446 Likes
on
3,154 Posts
'71 Pinto
#67
Senior Member
LI88.20-P-052891 - 212 rear bumper sticks out in area of rear lamp. Bumper experiences thermal expansion mounting rails (fender area) cannot sufficiently hold the bumper in place. If bumper is not equipped with additional latch, it should be replaced. Note since JAN11 bumpers are equipped with additional retaining tab.
#69
Senior Member
LI88.20-P-052891 - 212 rear bumper sticks out in area of rear lamp. Bumper experiences thermal expansion mounting rails (fender area) cannot sufficiently hold the bumper in place. If bumper is not equipped with additional latch, it should be replaced. Note since JAN11 bumpers are equipped with additional retaining tab.
I believe this is the discoloration. I usually leave my tray tucked in, but you can see on the side it's starting to fade.
#70
Out Of Control!!
Join Date: Jun 2008
Location: Earth
Posts: 10,557
Likes: 0
Received 18 Likes
on
18 Posts
Porsche Macan S SportDesign / Ex M-B's: 11 & 10 & 06 E350's, 02 S500
You guys with discoloration, do you leave your car out in the sun a lot? I don't, and I have my tray closed mostly, so it would be harder to tell if my car did have lack of UV protection on the wood. Though, I know for sure that there's been no fading yet (nice and dark/rich), in case I did keep the car for a long time, it would suck if the fading effects were slow enough to where the car would be out of warranty when I'd start to notice it.
#71
Newbie
Join Date: Nov 2010
Location: Northeast Ohio & SW FO
Posts: 14
Likes: 0
Received 1 Like
on
1 Post
2019 - S560 4Matic (designo Cashmere White Magno (matte finish) & 2013 - S550 4Matic (Andorite Grey)
You guys with discoloration, do you leave your car out in the sun a lot? I don't, and I have my tray closed mostly, so it would be harder to tell if my car did have lack of UV protection on the wood. Though, I know for sure that there's been no fading yet (nice and dark/rich), in case I did keep the car for a long time, it would suck if the fading effects were slow enough to where the car would be out of warranty when I'd start to notice it.
#72
Senior Member
You guys with discoloration, do you leave your car out in the sun a lot? I don't, and I have my tray closed mostly, so it would be harder to tell if my car did have lack of UV protection on the wood. Though, I know for sure that there's been no fading yet (nice and dark/rich), in case I did keep the car for a long time, it would suck if the fading effects were slow enough to where the car would be out of warranty when I'd start to notice it.
#73
Out Of Control!!
Join Date: Jun 2008
Location: Earth
Posts: 10,557
Likes: 0
Received 18 Likes
on
18 Posts
Porsche Macan S SportDesign / Ex M-B's: 11 & 10 & 06 E350's, 02 S500
Nope, mine was garaged at all times plus live in Cleveland and we have no sunshine! You can check if fading is occuring by opening your front door and compare the wood that is at the very front of the door and is tucked in next to the dashboard when the door is closed. There was a very noticeable difference on mine. Will post a picture when not on my phone.