Mr
Thread Starter
Newbie
Joined: Jan 2025
Posts: 2
Likes: 0
Mr
Hello MB people,
I have E200 2011 Bluetec, the car was running smoothly, until i went for a garage to change the engine oil .
the tech said that there was an oil leak from the seal convertor so we did seal convertor replacement and rear seal , after that the car start doing over rev on low speeds between 1-2/2-3 gear , and later some jerks comes up to the surface.
i was advised to do a Tranny fluid and convertor oil change but no help, it's getting worse.
yesterday, I changed the transmission but the problem still there.
please note that there is not a single fault code in ECU OR TCU .
I still have until Friday warranty for the gear. Maybe i can have an advise from someone who faced this issue.
i am in Dubai
I have E200 2011 Bluetec, the car was running smoothly, until i went for a garage to change the engine oil .
the tech said that there was an oil leak from the seal convertor so we did seal convertor replacement and rear seal , after that the car start doing over rev on low speeds between 1-2/2-3 gear , and later some jerks comes up to the surface.
i was advised to do a Tranny fluid and convertor oil change but no help, it's getting worse.
yesterday, I changed the transmission but the problem still there.
please note that there is not a single fault code in ECU OR TCU .
I still have until Friday warranty for the gear. Maybe i can have an advise from someone who faced this issue.
i am in Dubai
Super Member
Joined: Mar 2024
Posts: 618
Likes: 241
From: Chicago
19 GLA45, 86 560SL, former: 14 E550 4Matic, 09 E350 4Matic, 83 240D manual, 78 450SLC, 81 500SLC
You have a brand new transmission and the transmission appears to be slipping. But you have no fault codes...
It seems like whoever installed the new transmission did not do it correctly.
It seems like whoever installed the new transmission did not do it correctly.
