Command ntg 2.0 problem
Thread Starter
Newbie
Joined: Nov 2018
Posts: 4
Likes: 0
From: Queensland Australia
2006 ml350 petrol v6
Command ntg 2.0 problem
G'day all? I have recently had a problem with my W164 command system. It began after I had a battery issue, the main battery was replaced and the back up battery was tested. My problem is it powers up to the MB logo then powers down after a few seconds. All was working fine prior to the battery failure, I have tested evey fuse in the four fuse boxes including the one under the seat. I am unable to get it scanned easily because Im about 500klms away from the closet service centre. Any help would be appreciated. Thanks Brendan
MBWorld Fanatic!
Joined: Oct 2011
Posts: 7,107
Likes: 765
From: Bronx, N.Y.
2002 ML 320 & 2006 ML500
Brendan, turn the key to the on position and with a test light or DVOM, check both contacts on each fuse for 12v. Fuses 20 & 25 in the load compartment fuse box.
When you changed the battery, was the key in the ignition?
Last edited by Maj. Dundee; Mar 27, 2019 at 07:00 AM.
Thread Starter
Newbie
Joined: Nov 2018
Posts: 4
Likes: 0
From: Queensland Australia
2006 ml350 petrol v6
Thanks for your response, I have checked those two fuses all ok, the kwy was in the ignition at the time
MBWorld Fanatic!
Joined: Oct 2011
Posts: 7,107
Likes: 765
From: Bronx, N.Y.
2002 ML 320 & 2006 ML500
NEVER leave the key in the ign. when replacing components or parts, especially when needing a jump start..
Are there any other features that are not working?
Can you post a short video of the screen fading out?
Thread Starter
Newbie
Joined: Nov 2018
Posts: 4
Likes: 0
From: Queensland Australia
2006 ml350 petrol v6
Thanks for your reply, I have check both fuses and they are ok, I can also eject the Navi disk from the command unit. I'm unable to upload a video as the file is to big. Any assistance is appreciated
MBWorld Fanatic!
Joined: Oct 2011
Posts: 7,107
Likes: 765
From: Bronx, N.Y.
2002 ML 320 & 2006 ML500
