ML350 BT W166 Odd ABS issue
Thread Starter
Junior Member
Joined: Mar 2013
Posts: 36
Likes: 8
2002 ML 500
ML350 BT W166 Odd ABS issue
Hi Guys
Recently I changed a water pump, and sealed the vacuum pump while I was there, I had a friend helping who changed the PCV that goes to the Turbo.
All went ok except as soon as I drove it feels like the right front wheel goes into ABS at slow braking ????
Could it be just back luck that the speed sensor failed at that same time?????
or
I am wondering if there is any ABS or Speed sensor wiring/connectors around the back left hand side of the motor, he did remove and disconnect some of those brackets to get at the PCV.
My scanner shows a store transmission fault where all speed sensors have failed ??? Unfortunately will not show real time data for the speed sensors as it dosnt recognise the module ??? (Autel Scanner)
Any Ideas
Reagrds
Terry
Recently I changed a water pump, and sealed the vacuum pump while I was there, I had a friend helping who changed the PCV that goes to the Turbo.
All went ok except as soon as I drove it feels like the right front wheel goes into ABS at slow braking ????
Could it be just back luck that the speed sensor failed at that same time?????
or
I am wondering if there is any ABS or Speed sensor wiring/connectors around the back left hand side of the motor, he did remove and disconnect some of those brackets to get at the PCV.
My scanner shows a store transmission fault where all speed sensors have failed ??? Unfortunately will not show real time data for the speed sensors as it dosnt recognise the module ??? (Autel Scanner)
Any Ideas
Reagrds
Terry
Out Of Control!!
Joined: Apr 2019
Posts: 12,092
Likes: 6,868
From: Silicon Valley
W212 MY'14 M276-3.5NA @75kMi
Solution is to get a better scanner that's go9d enough to work with your chassis such as Launch cReader Elite MB.
Asn8s your Autel does not shows ESP whell sensor data ???
Asn8s your Autel does not shows ESP whell sensor data ???
