Crank Won't Start
Thread Starter
Newbie
Joined: May 2025
Posts: 4
Likes: 0
2014 ML350 4Matics
Crank Won't Start
Hi there! When I try to start my car today it just crank but won't turn over. Read code P2088 2092 2094 2098 camshaft acurator low circuit codes, sometimes have 0498 EVAP Vent valve control circuit low 0031 HO2S heater control circuit low bank 1 sensor 1. Had other low circuit code as well as ECM communication codes. Checked fuses in the engine bay, battery seems fine, tried jump start, oil is ok. All visible wires seem fine, but I do have pending water in the truck recall that I didn't go, could it be fuel pump control module or other causes? Seems to be some kinda wiring issues.
What is the cause? Low battery? Car crank strong though.
What is the cause? Low battery? Car crank strong though.
Last edited by zxz235650; May 21, 2025 at 09:00 PM.
Out Of Control!!
Joined: Apr 2019
Posts: 11,924
Likes: 6,776
From: Silicon Valley
W212 MY'14 M276-3.5NA @75kMi
CRANK NO START
this obvious step will help you understand without blaming the battery.
Seems you're dealing with compromised engine sensors. The fault codes will show to what extent.
Last edited by CaliBenzDriver; May 21, 2025 at 09:01 PM.
Thread Starter
Newbie
Joined: May 2025
Posts: 4
Likes: 0
2014 ML350 4Matics
Member
Joined: Oct 2023
Posts: 117
Likes: 45
From: Buchanan, SK CANADA
2013 ML350 Bluetec
You've got a bit of a dog's breakfast there but the ones that are stopping it from starting are likely the cam actuator codes. Both banks - sudden onset - I'd figure out what fuse is involved and start there.
