timing...
01-09-2011, 07:58 AM
#1
Newbie
Thread Starter
timing...
Does anyone know the timing for 280E w123?
My car runs smooth, till i put the hammer down. When i give more gas, the car jerks almost if it doesn't get enough gas or something... Any ideas what it can be? I did recently replaced the spark plugs.
My car runs smooth, till i put the hammer down. When i give more gas, the car jerks almost if it doesn't get enough gas or something... Any ideas what it can be? I did recently replaced the spark plugs.
01-09-2011, 08:26 PM
#2
MBWorld Fanatic!
Did it happen BEFORE YOU CHANGED THE PLUGS?
OR is this a new thing after the plugs?
Did you use the correct copper plug? that engine won't like platinum plugs.
Did you use the correct copper plug? that engine won't like platinum plugs.
01-10-2011, 10:02 AM
#3
Newbie
Thread Starter
Spark plug infomation
It happened after i installed the new plugs. It had NGK plugs and i replaced it with Bosch W7bc. (that is what the sales people tell me). i'm going to check it tonight.
Last edited by Stephanus 007; 01-12-2011 at 04:36 AM. Reason: wrong info given
01-12-2011, 04:37 AM
#4
Newbie
Thread Starter
I checked the plugs, I replaced it with WR8DC +. What is the wrong plugs. I've just ordered my new plugs. going to replace it tonight. the right plugs are W7bc.
I've done some research, and according to another mercedes forum website, the "r"(wr8dc+) stands for resistor. the car i'm driving already have a resistor installed. that is why it is not running smooth...
I've done some research, and according to another mercedes forum website, the "r"(wr8dc+) stands for resistor. the car i'm driving already have a resistor installed. that is why it is not running smooth...
