I have a 2005 s600 with 80k miles and recently had my high pressure hose go, so instead of replacing it and having to need 10 liters of pentosin and all that other good stuff, I'm going the strutmasters route.

With that said, how much could I get for 4 good stuts and valve blocks and everything else associated with it? Everything else is good except for the high pressure line, obviously.

Thanks in advance.

 

If the only thing that failed is the line you should get it repaired cheap at a hydraulics /forklift service place and buy the big jug of pentosin cheap on Amazon

An abc pump , strut or valve block failure is when to switch to strutmasters, not a hose failure

 

That's exactly what I did. It was the "P" line on the front valve block that went out, replaced the line for 90 bucks, and 2 liters of pentosin for 40, so I fixed for 130ish.

 

ABC is nothing to fear when you consider the advantages it brings.

Any local hydraulic shop can repair it for you quickly, cheaply and easily. They can replace the flexible hose with a new section that is welded, compression fitted or flared onto the existing pipes.

Nick