Advice on how to remove stuck caliper bolts?
#1
MBWorld Fanatic!
Thread Starter
Advice on how to remove stuck caliper bolts?
Tried to replace rear discs and the tech broke a socket on the torx bolts and could not remove the rear calipers any suggestions on how to get them out!!???
#2
My tech had the same problem with rear calipers, he ended up breaking a one socket and 2 extension before getting it off. He ended up spraying it with some wd-40 or something similar and letting it sit while he finished up the other ones. Hopefully you have it on a lift as I'm sure it will help...good luck!
#5
MBWorld Fanatic!
#6
Super Member
Join Date: Jul 2008
Location: Brooklyn, NY/Tampa, FL
Posts: 831
Likes: 0
Received 0 Likes
on
0 Posts
2005 BLK/BLK E-Double Nickel.
i would spray liquid wrench first and bang with a heavy hammer or the equivalent second to break the rust/corrosion. heating is secondary and always last resort, becasue i have seen instances where torching has expanded thread that bolts go in to.
Trending Topics
#8
Super Member
Join Date: Jul 2008
Location: Brooklyn, NY/Tampa, FL
Posts: 831
Likes: 0
Received 0 Likes
on
0 Posts
2005 BLK/BLK E-Double Nickel.
#9
MBWorld Fanatic!
Join Date: Oct 2005
Location: D.C. METRO AREA
Posts: 1,070
Likes: 0
Received 1 Like
on
1 Post
Nissan GT-R cobb/midpipe/ic piping/wastegate actuators/tials
NO no bro, it's all good and you're right. My usual route would be:
try to open it.
bang on it to loosen rust/loctite
spray it
bang on it
heat it, as a last resort..
try to open it.
bang on it to loosen rust/loctite
spray it
bang on it
heat it, as a last resort..
#10
Super Member
Join Date: Jul 2008
Location: Brooklyn, NY/Tampa, FL
Posts: 831
Likes: 0
Received 0 Likes
on
0 Posts
2005 BLK/BLK E-Double Nickel.