Meziere WP136, How to install??
#1
Senior Member
Thread Starter
Meziere WP136, How to install??
has anyone has a DIY guide in how to install this Meziere WP136??
Also, if you install a Meziere WP136 or a CM90 pump with the OEM heat exchanger, would it get any improvement??
Also, if you install a Meziere WP136 or a CM90 pump with the OEM heat exchanger, would it get any improvement??
#2
MBWorld Fanatic!
Join Date: Sep 2008
Location: murfreesboro,tn
Posts: 3,152
Likes: 0
Received 0 Likes
on
0 Posts
2003 porsche 996 turbo
im not real familiar with your setup but i know on the s/c v6 unless you upgrade the h/e with a better flowing unit the pump upgrade has minimal effect
#3
Former Vendor of MBWorld
iTrader: (1)
Join Date: May 2008
Location: Houston
Posts: 12,139
Received 293 Likes
on
242 Posts
2003 W211 E55, 2003 W220 S600
the meziere pump mounts vertically in the stock location. you may have to fab a bracket for it. the rubber fastener on the stock hoses have to be cut so the hoses can slide easily over the inlet and outlet of the meziere pump.
#6
MBWorld Fanatic!
#7
Senior Member
Thread Starter
Trending Topics
#9
MBWorld Fanatic!
Join Date: Feb 2011
Location: miami / delray beach
Posts: 2,841
Received 202 Likes
on
155 Posts
2014 E63s amg 4matic, 2009 C63, 2006 E55 AMG , 2001.5 AUDI S4 stg 3+ w/meth
and how did you do it with the electrical fittings since they plug in you can just touch it to battery to power on to prime... i am assuming you hook up the pump by pluging in the electrical connector to factor without the outlet hooked up and turn ignition to ACC an run pump until coolant comes out and then turn ignition off and hook hose up to outlet of pump then mount then done?
thanks in advance
#10
MBWorld Fanatic!
Join Date: Jan 2007
Location: Alabama
Posts: 1,951
Received 220 Likes
on
174 Posts
2012 Volt - 2005 E55 - 2011 G55 - 2013 GL63
Checked the install on my pump today and it appears the unit is upside down, I know it needs to mount vertically and not horizontal. The coolant lines are running to the top of the unit.
I assume this would greatly affect the flow or does it matter?
I assume this would greatly affect the flow or does it matter?