Floored headers and motor mounts
#1
Super Member
Thread Starter
Join Date: Feb 2008
Location: Texas
Posts: 756
Likes: 0
Received 3 Likes
on
3 Posts
e55 w/LET TUNE Drinks: vodka STRAIGHT Wheels: 19" HRE 547r Mods:FF headers ASP Pulley
Floored headers and motor mounts
anyone had to change the mounts after the header install?
any tricks? i cant seem to figure out how to get the drivers side out since the header almost rest on the top bolt
any tricks? i cant seem to figure out how to get the drivers side out since the header almost rest on the top bolt
#2
Super Member
Thread Starter
Join Date: Feb 2008
Location: Texas
Posts: 756
Likes: 0
Received 3 Likes
on
3 Posts
e55 w/LET TUNE Drinks: vodka STRAIGHT Wheels: 19" HRE 547r Mods:FF headers ASP Pulley
had to loosen the first 2 primaries. then i could get a socket on the top bolt
all in all not to bad. took me 3 hours total but could do it again under an hour (w/airtools)
had to use a shovel for leverage to move the sway bar :P
all in all not to bad. took me 3 hours total but could do it again under an hour (w/airtools)
had to use a shovel for leverage to move the sway bar :P
#3
Just a suggestion to anyone else who might be installing headers. Header install is the perfect time to change your old mounts. With the factory manifolds out of the way, the new mounts go in like butter.
#4
Super Member
#6
MBWorld Fanatic!
Yeah ... wish I'd known this when I did my headers recently *sigh* oh well ... good advice!
#7
MBWorld Fanatic!