SICAMG

I tried to get into my transmission data to clear adaptives and it,DAS" will not let me and say's communication fault.
But I can get into everything else engine wise. I do have a Troy Merry tcm and was thinking maybe it is blocking anything coming in. Anyone run into this.

Plutoe

If you have any MB TCU with tune you are foooked plus now it will get expensive to correct the issue

herpderp

The TCU may by design be blocked to prevent people from snooping Troy's hard work. Have you emailed them?

SICAMG

I will on Monday...he only responds M-F.
Plutoe...I have gotten into other brands of TCU's...DTK and Eurocharged so seems strange.

E55Greasemonkey

Who is Troy and what has he done with your TCU?

SICAMG

Troy owns MK Ultra

machild

I'm pretty sure I reset my trans adaptations after I installed Troy's TCU. So, I must have been able to communicate with the trans to do that.

SICAMG

Good to know...I will give it a try again Monday.

BenzNinja

iTrader: (4)

Just use the Cak /Kline cable set included with the C4
module one bench, connected to 12V hook up direct CAN to it and run DAS

SICAMG

Troy said there should be no issue so that's off the table.
Tried getting in multiple ways and still can not.But.... It also will not "read" vehicle and I have to manually inter the vehicle data but then I can get into body and engine and read codes no problem.

Benzninja I have a old c3 system with no other cables.