When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Best quality is to have someone competent spray your oem emblems black ... but I've used ebay badges and they do fine ... and for how cheap they are you can refresh them once a year
Got them yesterday. Quality is good but they are definitely not OEM and not for w213 cause have a different shape (not a flat face) and just a bit smaller than those which comes on the car. Will use them after full wrap. 1 2 3
Ebay emblems
Got these in the mail today! They look good and seem to be the exact same size as my OEM badging. I got them on ebay from a US seller. If I remember correctly this the same seller I purchased my RS7 badges from in the past.
Ebay emblems
Got these in the mail today! They look good and seem to be the exact same size as my OEM badging. I got them on ebay from a US seller. If I remember correctly this the same seller I purchased my RS7 badges from in the past.
can you post a link please. Looking for same set atm.
Ebay emblems
Got these in the mail today! They look good and seem to be the exact same size as my OEM badging. I got them on ebay from a US seller. If I remember correctly this the same seller I purchased my RS7 badges from in the past.
those are not exact same size as oem
there are clear to me differences but at the end of the day it doesn't matter it's minor and no one will know but you
there are clear to me differences but at the end of the day it doesn't matter it's minor and no one will know but you
I went out and chechecked the sizing, too me they are close enough to justify spending around $100 total. I’d rather them be slightly bigger than smaller like I’ve seen in my search. I think I will be able to space them out better once on the car than how they appear in the wrapper. If any potential buyers are that picky then I guess you should get your oem badging painted. I will post pics after the new year once my full car PPF is done.
Just had the car wrapped and they had trouble with the "4MATIC+" piece and the "BITURBO" spacing to the point where it was just too long / spaced out on the aftermarket pieces.... They ended up putting the "4MATIC+" badge starting under the "8" in "V8" to get it to all fit under the swoop. How does yours look with the aftermarket fender badge? Any pictures of the finished product? Thanks!
Just had the car wrapped and they had trouble with the "4MATIC+" piece and the "BITURBO" spacing to the point where it was just too long / spaced out on the aftermarket pieces.... They ended up putting the "4MATIC+" badge starting under the "8" in "V8" to get it to all fit under the swoop. How does yours look with the aftermarket fender badge? Any pictures of the finished product? Thanks!
i have same problme here. iv bought 2 set of aftermarket bright black emblems but same problem. the space in letters is too big and it is very noticeable. i tried to sitck the letters seperately but ended up with they were not exact leveled up and looked low quality. so second set i just sticked them up as close as V8 emblem in an aesthetic way. my picture shows them all. hope it helps.
Last edited by scoobyhumme; 09-21-2020 at 10:52 PM.
Best quality is to have someone competent spray your oem emblems black ... but I've used ebay badges and they do fine ... and for how cheap they are you can refresh them once a year
Exactly what I just did when I turned them all from chrome to gloss black.
12-14-2018, 01:32 PM
