MBWorld.org Forums
0 2018/03/21 20:27:19
0 2018/03/21 20:27:19
0 2018/03/21 20:27:19
0 2018/03/21 20:27:20
0 2018/03/21 20:27:20
0 2018/03/21 20:27:20
Remove the
Remove the
0 2018/03/21 20:27:20
0 2018/03/21 20:27:22
0 2018/03/21 20:27:22
0 2018/03/21 20:27:22
0 2018/03/21 20:27:23
0 2018/03/21 20:27:23
0 2018/03/21 20:27:23
0 2018/03/21 20:27:23
0 2018/03/21 20:27:23
0 2018/03/21 20:27:24
0 2018/03/21 20:27:24
0 2018/03/21 20:27:24
0 2018/03/21 20:27:24
0 2018/03/21 20:27:24
remove the supercharger tension pulley
remove the supercharger tension pulley
0 2018/03/21 20:30:26
Remove the double idler pulley
Remove the double idler pulley
0 2018/03/21 20:32:05
0 2018/03/21 20:33:57
Here are the three pulleys that needed to be removed FYI one of them is the belt wrap kit so disregard that one if you don't have the kit. Alto the black 4 bolt pulley is not pictured here and will also need to be removed.
Here are the three pulleys that needed to be removed FYI one of them is the belt wrap kit so disregard that one if you don't have the kit. Alto the black 4 bolt pulley is not pictured here and will also need to be removed.
0 2018/03/21 20:37:48
Here is the final bolt count minus the few bolts underneath the supercharger tension pulley assembly and the 4 bolts that attach the black pulley on and the individual pulley bolts from the other 2 or3 pulleys if you have the wrap kit.
Here is the final bolt count minus the few bolts underneath the supercharger tension pulley assembly and the 4 bolts that attach the black pulley on and the individual pulley bolts from the other 2 or3 pulleys if you have the wrap kit.
0 2018/03/21 20:39:53
Here was my problem.
Here was my problem.
0 2018/03/21 20:43:46
Here is the old water pump as you can see the seal to the bearings went back and it looks like oil leaked onto the turbine.
Here is the old water pump as you can see the seal to the bearings went back and it looks like oil leaked onto the turbine.
0 2018/03/21 20:43:47
Once removed you will need to clean up all the dirt that fell onto the inner water pump area and clean out the gasket grove as well. I placed a paper towel where the lower inlet is to the motor to block dirt from getting into the motor.
Once removed you will need to clean up all the dirt that fell onto the inner water pump area and clean out the gasket grove as well. I placed a paper towel where the lower inlet is to the motor to block dirt from getting into the motor.
0 2018/03/21 20:43:48
here it is with the new gasket placed in the groove and cleaned out. here is a picture that shows the paper towel that I placed to block debris from getting into the motor.
here it is with the new gasket placed in the groove and cleaned out. here is a picture that shows the paper towel that I placed to block debris from getting into the motor.
0 2018/03/21 20:46:35
Here is the new water pump going in. Remember to take a lot of pictures so you don't put the wrong bolt in the wrong hole.
Here is the new water pump going in. Remember to take a lot of pictures so you don't put the wrong bolt in the wrong hole.
0 2018/03/21 20:49:14
I used 1 and a half of these mixed 50/50 with distilled H2O. remember that this engine will self bleed the air out. You will need to carry some with you when you drive and fill it as it gets low.
I used 1 and a half of these mixed 50/50 with distilled H2O. remember that this engine will self bleed the air out. You will need to carry some with you when you drive and fill it as it gets low.
0 2018/03/21 20:51:03
Use the BLUE loc tite on every bolt. Also don't over tighten the bolts this is aluminum after all. I went maybe a quarter of a turn past when I felt they were snug. just get a sense of how much force was required to remove them (not much) and use that as a reference for when you are tightening your bolts.
Use the BLUE loc tite on every bolt. Also don't over tighten the bolts this is aluminum after all. I went maybe a quarter of a turn past when I felt they were snug. just get a sense of how much force was required to remove them (not much) and use that as a reference for when you are tightening your bolts.
0 2018/03/21 20:52:56
Single blue wire above with speaker wire on the carpet.
Single blue wire above with speaker wire on the carpet.
0 2018/05/30 12:38:35
0 2018/05/30 12:39:49
The speaker wires
The speaker wires
0 2018/05/30 12:42:16
0 2018/05/30 12:52:44
8 wires in 1 black wire.
8 wires in 1 black wire.
0 2018/05/30 12:53:32
Passenger side of black trunk box
Passenger side of black trunk box
0 2018/05/30 12:54:27
Driver's side black trunk box
Driver's side black trunk box
0 2018/05/30 12:54:58
0 2018/05/30 13:37:32