W220 DIN or Doulble DIN Installations?
pbxsc4n
1. i have to turn the key all the way,about 1 click from starting the car to get and keep the audio to work.
2. I have to turn the double din radio off manually
3. Everytime i turn up the radio too loud, the audio cuts off and i have to turn the car off and turn it back on to get back the audio..
i have a sony 4/3 channel amp and the rest is all rewired because i couldn't find a wiring harness. Any suggestions because i
So you will have to use the cig lighter for acc power for the new radio and this should turn it on/off properly. The next problem is usuall caused by a low impeadence load on the amp...Probably caused by the sub which is dual voice coil 1 ohm and you have to rewire it in series to get a 2 ohm load and then you have to make sure your amp will handle a 2 ohm mono load... Depending on how you have the front and rear speakers wired that can also be an issue... It might be best to disconnect 2 of the 4 channels at a time to see which ones are causing the amp to shut down...
Scott La Jolla Audio
Trending Topics
The Best of Mercedes & AMG
Scott La Jolla AUDIO
Still trying to get a better radio reception.. can u please explain what blue wire(the one that powers up the antenna) ur talking about(kinda confused on that one). Is it at the end of the wires beside the speaker wires that is connected to the amp?
Also, did u get your steering wheel control to work..still trying to figure out what wires to connect for that..
Scott La Jolla Audio




