iDataStart ADS-BZ3 Remote Starter (with heated seat control) DIY install
#26
Hello,
I am stuck and can not program my module. despite resetting the module. nothing changes. when I connect the cables and put the ignition on ON position all LEDs are off. the only thing happens is blinking red, green, red after a few seconds after the start. my car is not PST and I do not need to connect the harness to the junction underneath the seat. However, I checked and there is only one cable in that junction. any suggestion?
Thanks
I am stuck and can not program my module. despite resetting the module. nothing changes. when I connect the cables and put the ignition on ON position all LEDs are off. the only thing happens is blinking red, green, red after a few seconds after the start. my car is not PST and I do not need to connect the harness to the junction underneath the seat. However, I checked and there is only one cable in that junction. any suggestion?
Thanks
#28
Senior Member
Join Date: Dec 2018
Location: New York
Posts: 267
Received 55 Likes
on
41 Posts
2010 E350 4Matic sedan
i think I am going to buy it. I just downloaded the weblink app and registered with a log in and password. Also, I know where the module is located behind the dash and I can easily get to it. Is it just a matter of plugging this weblink Ads-wilm-ap1 into the module and then opening the app and updating anything through there?