iDataStart ADS-BZ3 Remote Starter (with heated seat control) DIY install

Reply Subscribe

Thread Tools

Search this Thread

Rate Thread

Nov 4, 2019 | 09:17 AM

#26

TheRulesLawyer

Senior Member

Joined: Mar 2014

Posts: 402

Likes: 6

C350

Quote:

Originally Posted by Fred22

Hello,
I am stuck and can not program my module. despite resetting the module. nothing changes. when I connect the cables and put the ignition on ON position all LEDs are off. the only thing happens is blinking red, green, red after a few seconds after the start. my car is not PST and I do not need to connect the harness to the junction underneath the seat. However, I checked and there is only one cable in that junction. any suggestion?
Thanks

Did you complete the programming on their website? Just plugging it in probably won't work.

Nov 14, 2019 | 12:27 PM

#27

Fred22

Newbie

Joined: Oct 2019

Posts: 3

Likes: 0

c300 Mercedes 2009

Thanks for the reply, apparently I was a bit fast for the process. It is installed and working now.

Dec 29, 2019 | 09:19 AM

#28

pb39374

Senior Member

Joined: Dec 2018

Posts: 285

Likes: 60

From: New York

2010 E350 4Matic sedan

Quote:

Originally Posted by benzdude

I still have this Android cable available if you need to reprogram and/or firmware update your modules.
iDatastart ADS-WLM-AN1 Weblink Moblie Programming cable for ADS-BZ3 - $50

I had this remote starter installed about a year ago. I want to go in and make some changes to the options (i.e. change how many minutes delay). I have been avoiding making an appointment with the original installer. I just came across this WeblinkMobile product.
i think I am going to buy it. I just downloaded the weblink app and registered with a log in and password. Also, I know where the module is located behind the dash and I can easily get to it. Is it just a matter of plugging this weblink Ads-wilm-ap1 into the module and then opening the app and updating anything through there?