RRnelcheeze

picked up these HRE 845R's on mbworld's classifieds for a good price, they did need some refinishing. The barrels were not too bad, a good cleaning and polishing brought them back, but the centers is where they really needed some work, I was going to just polish them up and put them on as is, but the chips on the centers were just bothering me.. Had them coated in P7 Grey over at Orange County Plating, they have done a few sets of wheels for me, and they do a great job. Even talked to them about the baking temp and from my research should be within the temps that HRE uses, but not really too concerned with that. Some old HRE's got a make over.
I do have a set of Forgestar F14's that I will be posting for sale as soon as i can get pics.

Wheels as they were when i got them

you can see some of the chips on the wheel centers, this wheel i would probably rate at 4/10.

barrels decreased and cleaned

after a good polishing

Centers back from powder coating

back together after replacing a few of the fasteners, man were those a pain to find, M8 10.9 grade bolts.

P.7 Grey, its like a satin finish with a texture to it, with a bit of a shimmer.

togaclk55

Nice

hyperion667

looks good...is that an older wheels model?
they show a lot of caliper and rotor too.....

nice

discoduck

Looks great. Open brake concept

novae500

looks good. I did something similar as well. Picked up some from the classifeds here and got them re powdercoated.

M1RAG3

great job...looks really good...I love the curvature of the wheel face...HRE = pure baller.

RRnelcheeze

Thanks all! yes this is an old HRE model, discontinued.

otakki

Rims like this always make me wonder if the spokes are going to snap under too much load or torque. However, they do look real nice.