D_Star

Hi guys,

does any one know the 1/4 mile time for our C32s from MB?

uownme

15.6@92mph

D_Star

after doing more research, i found 13.6. however none of what i found was officially from MB. tht's why i asked. but 15.6??? that's unbelivablily SLOW

newton22

Haha, its not 15.6. 13.6 sounds right. Mercedes doesn't have official quarter mile times.

Bif powell

Seems like with just a little modification people are doing mid-to-high 12's?

amgmark

Man.. I hope that's not your track time..

The typical times I have seen quoted are around 13.6 @ 106mph

I found this thread with a search..

https://mbworld.org/forums/c32-amg-c55-amg-w203/84015-motor-trend-s-c55-1-4-mile-results.html

D_Star

hope my baby can close the gap one day
thnx mark for the info~

alumar

With a reflash/tune and ASP Pulley, plugs, green filters, 102 Sunco my best at the www.wingedwarrior.net event was 13.03 @ 111mph

uownme

I think many people had their sarcastic meters turned off..

ClayJ

13 and change....

TopGun32

very nice trap speed.

i think if you run 255 and better rubber.. you should be in 12's

12.9xx

alumar

my 60' kinda sucked at 2.013, most of the cars there were putting down 1.65's - 1.9's ... but had a mid ranged trap speed.

Its funny to me how many people came over and were like...what the hell is that thing? Cant tell you how many folks thought it was a hopped up C230 Kompressor.

The AWD AMS and Busch Evo VIII's and few of the suped up STI's at that event were putting down mid 11's @ 126+ ... crazy fast

I need someone that is better at launching to take it for a spin, i see lots of people on this board pull 12's out of the C32, just havent been able to breach it.[/

D_Star

Launching!!! a pain in the ***! after researching some posts here, i went on and tried it, but never worked

I brake torque to about 2800RPM and then release brake and give gas, the wheels spin like my laundary machine

am i suppose to brake torque to about 2800RPM and release both brake a gas and then give a 3/4 then floor??

uownme

Ease into the gas, modulating according to how much traction you have.

FongFlex

my best 60' is 1.84s (i also have the renntech chip and pulley). this is what i did:

brake start at 1500rpm's. as you ease off the brake pedal, ease into the throttle. don't floor the car until you feel that your car has enough traction; and when you floor it, don't smash the pedal, but do it smoothly to maintain the most traction.

hope this helps.

m3_eater

alumar, get an LSD. It's worth every penny.

<--- biased